Part Number: TPA3111D1-Q1 Tool/software: Hello team,
In the previous QA, your team answered that device will be turned off if 2.5A flows due to the overcurrent.
What is the response time from the overcurrent to the turning off the device?
Regards,
Hi…
Part Number: TPA3111D1-Q1 Hi Expert:
because we are finding 10ohm power dissipation package size , I would like to know TPA3111D1-Q1 "AVCC" pin( internal LDO) max current when PVCC (input) 12V condition
thank you
Part Number: TPA3111D1-Q1
Hi Expert,
I am getting a pop noise from mono speaker as well as stereo speakers when powering up my device. I am using TPA3111 for mono audio. Noise is coming even in amplifier disable mode. Refer the schematic of amplifier…
Part Number: TAS5441-Q1 Other Parts Discussed in Thread: TPA3111D1-Q1 , TPA3112D1-Q1 Tool/software: Hello,
My customer is asking about load dump in TAS5441-Q1.
Are TPA3111D1-Q1 or TPA3112D1-Q1 load dump function?
Also, are there any other in-vehicle class…
Part Number: TPA3111D1-Q1 Hi experts,
See below from the datasheet. What does that circle part mean? Can you please show how you will get the table 3 power results based on the information listed in table 3? Thanks!
Part Number: TPA3111D1-Q1 Hello
Just wondering if there are gerber data files available to accompany the application schematic shown in Fig.6 of the SLVA824 PDF File, entitled Class-D Amplifier External Load Diagnostics ?
www.ti.com/.../slva824.pdf
Thanks…
Hi,
Adding some comments on each question below:
-20C should be supported, unfortunately I don't have variation over temperature numbers, but the device should be operative down to the specified -40C.
PLIMIT is a voltage limiting feature, when enabled…
Part Number: TPA3111D1-Q1
Hi team,
I have 3 questions about fault feature of TPA3111-Q1.
1. About DC detection, does this feature intend to defect the leak DC current through the defective input coupling capacitor?
2. About the short circuit, how much…
Part Number: TPA3111D1-Q1 Hi,
I am using this design for the single ended in my application.i am observed POP noise during Power ON and sleep to wake-up
The AMP take around ~16ms to stabilize and produce the output after power enabled. When i measure…
