Hi Adam,
We had decided to delete PFFB circuit on TPA3244 due to the fault issue.
So, we are going to redesign PCB layout without PFFB circuit.
Thanks for your support.
Regards,
Jeffrey
Part Number: TPA3244EVM Other Parts Discussed in Thread: TPA3244 Dear All,
I'm finding the gerber data of TPA3244 EVM for layout verification.
But I can't find anything.
If you have that gerber data I wanted, please send me that.
Regards
Jeffr…
Part Number: TPA3244EVM Other Parts Discussed in Thread: TPA3244 , TEST Hello!
I have configured the TPA3244EVM for PBTL connected to an 4Ω load. The datasheet specifies that the amplifier has an inverting voltage gain of 20dB (10V/V). But I measure…
Part Number: TPA3244EVM Other Parts Discussed in Thread: TPA3244 , TPA3245 Hi,
A customer had measured the gain of TPA3244EVM in SE inputed BTL mode. His measurement gain was 18dB, but it did not correspond with the gain of the datasheet. The specification…
Hi Anatoliy,
TPA3255EVM, TPA3251EVM, TPA3245EVM, TPA3244EVM, TPA3221EVM and TPA3220EVM are all compatible with the SideGig-Guitar Evaluation Module board!
The power supply would have to be one that you have however.
Hope this clarifies things.
Best Regards…
Other Parts Discussed in Thread: PCM5242RHBEVM , TPA3244EVM , TEST hello
I Have used the PCM5242RHBEVM + TPA3244EVM, and when input with Coaxial SPDIF or Optical, there is no output.
I have followed the jumper setting as configulation tab, but it also no output…
Hi
Output configuration is BTL. And I need data at THD+1= 1%
When Input type is single ended op-amp(NE5532A) must be used? like TPA3244EVM circuit diagram?