TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel


Search tips
Showing 27 results View by: Thread Post Sort by
  • TPA3255: High idle-power and extreme hot coils

    Matthias Loy
    Matthias Loy
    TI Thinks Resolved
    Part Number: TPA3255 Other Parts Discussed in Thread: TPA3251 , TPA3251EVM , Hi everyone, I'm developing a very small amplifier for selfpowered speakers. My problem now is Heat! The outputfiltercoils are running extreme hot in a short time ( 100°C…
    • over 4 years ago
    • Audio
    • Audio forum
  • RE: TPA3251: TPA3251 output power

    Robert Clifton56
    Robert Clifton56
    Hi Darren, You can if you include a single-ended to differential op-amp configuration. I'd recommend looking at the TPA3251EVM to see how we do it. Regards, Robert Clifton
    • over 6 years ago
    • Audio
    • Audio forum
  • TPA3251: THD vs. Frequency curve

    Wiky Liao
    Wiky Liao
    TI Thinks Resolved
    Part Number: TPA3251 Hi Team, I use TPA3251EVM and test its THD vs. freqnency performance, but my test result is really higher than datasheet description, could you help to check if it is normal? thanks. PVDD=36V, SE input, BTL, 4ohm load, output…
    • over 6 years ago
    • Audio
    • Audio forum
  • Answered
  • RE: TPA3255EVM: Reducing Noise

    Robert Clifton56
    Robert Clifton56
    Resolved
    Hi Jerry, Funny you say this. I changed out the NE5532 on the TPA3251EVM a couple of years ago with the OPA1678 device. There should be no problem switching out the op-amps. For the resistors, changing to a 2kohm resistor shouldn't cause any issues…
    • over 5 years ago
    • Audio
    • Audio forum
  • RE: TPA3251: PFFB problem and OC protection issue

    aggil liang
    aggil liang
    Hi Justin You can open the pcb latout file using ALTIUM DESIGNER or PROTELL 99SE or another tools, the file is ok. We connnet the same input audio signal to the TPA3251EVM, we test the CLIP_OTW waveform, it is as same as our PCB, But the EVM don't…
    • over 7 years ago
    • Audio
    • Audio forum
  • Answered
  • RE: class D amplifie Guitar

    Robert Clifton56
    Robert Clifton56
    Resolved
    Hi Anatoliy, TPA3255EVM, TPA3251EVM, TPA3245EVM, TPA3244EVM, TPA3221EVM and TPA3220EVM are all compatible with the SideGig-Guitar Evaluation Module board! The power supply would have to be one that you have however. Hope this clarifies things. …
    • over 5 years ago
    • Audio
    • Audio forum
  • Answered
  • RE: TIDA-00874: Availability

    Robert Clifton56
    Robert Clifton56
    Resolved
    Hi Jiri, We actually don't sell that board. However we do sell the TPA3251EVM which uses the same class-D amplifier as the TIDA-00874. We also have the TAS3251 and an EVM for that device if you need a digital input with the same amount of output power…
    • over 7 years ago
    • Simulation, hardware & system design tools
    • Simulation, hardware & system design tools forum
  • TPA3251: TPA3251 EVM test report

    Sean ZHang35753
    Sean ZHang35753
    TI Thinks Resolved
    Part Number: TPA3251 Other Parts Discussed in Thread: TPA3255 , Hi, Could you please provide TPA3251EVM and TPA3255 EVM test report to show TPA3251EVM and TPA3255 EVM PBTL mode can support 350W and 600W output respectively? Best Regards Sean …
    • over 8 years ago
    • Audio
    • Audio forum
  • RE: TPA3251: Single mono output from TPA3251

    Robert Clifton56
    Robert Clifton56
    Hi John, For inputs C and D you would want to ground them if they are not in use. The information regarding setup configurations can be found here: http://www.ti.com/lit/zip/slac735 . Regarding the outputs to C and D, the only thing you need connect…
    • over 8 years ago
    • Audio
    • Audio forum
  • Answered
  • TPA3251 Heasink design

    KANJI SHIBATANI
    KANJI SHIBATANI
    Resolved
    Other Parts Discussed in Thread: TPA3251EVM , TPA3251 Hello I had wrote following Post on Dec. 2015, but I had no answer yet. My customer pushes me about this, so I change hte subject name and change my question. https://e2e.ti.com/support/amplifiers…
    • Resolved
    • over 9 years ago
    • Audio
    • Audio forum
<>

Didn't find what you are looking for? Post a new question.

  • Ask a new question