Part Number: TPA6304-Q1 Tool/software: Hi,
We are working on bringing up the TPA6304-Q1 in the Quectel SC668s SOM with the Android platform. We need the driver source code or the I2C set commands. Regards,
SanthanaKumarS
Part Number: TPA6304-Q1 Other Parts Discussed in Thread: TAS6584-Q1 , TAS6511-Q1 Tool/software: Hi,
I'm using a TPA6304 using the same shematic of the evaluation board. I need to read the open load condiction continuosly, but I'm experiencing some issue…
Part Number: TPA6304-Q1 Tool/software: HI TI team， the Spread Spectrum of TPA6304 worked at 2.3MHz have three frequency noise at AM band，
the pictures show the spread Spectrum of 2.3Mhz at s pectrum analyzer as follow:
Part Number: TPA6304-Q1 Tool/software: Hi TI team，
the tp6304 can effectively drive DC coupled speakers，
but it can't drive AC coupled speaker，there is small pop noise at the AC speaker，
it continuously perform DC diagnosis，
Part Number: TPA6304-Q1 Tool/software: Application is driving a voice coil actuator that needs to be able to hold a position indefinitely. Need to be able to set the analog input pin with a DC voltage. Can this part support DC coupled analog inputs?
Part Number: TPA6304-Q1
What is the expected effect at die level in case a short to ground in pin 8 ( IN_REF ) for the TPA6304-Q1. In this pin, we have a RTN (Return) signal coming from a DSP. Or what could cause a leakage on IN_REF to DVSS?
Part Number: TPA6304-Q1 Tool/software: Hello TI team,
Now, we have a special application that uses only 1CH of this IC.
Only using channel 3 for subwoofer, and other channels are open.
At this application, the DC Load Diagnostics can't pass at MUTE…
Part Number: TPA6304-Q1 Tool/software: Hello TI Team,
Now we did below operations:
4CH connected normally --> Power up --> Normally run --> one of channels short to GND/Battery --> nFault pin changed from high to low
--> Read registers : 0x0A…
