Hi,
You do not need to use the CLK, HPD, CEC lines of TPD12S016. You do need to supply VCCA (for proper ESD protection) and GND, then any other pin is optional. Is there any other function of TPD12S016 you are using (i.e. 55 mA load switch)? If not…
Other Parts Discussed in Thread: TPD8S009 Hi,
I am using HDMI 1.4 supports chip in my design, but for ESD protection have used TPD8S009.
The ESD protection chip supports HDMI 1.3 and display port data rate.
Shall i use this ESD chip for HDMI1.4…
Hello William,
I would suggest using DS90CF383 -> DS90CF386 -> TFP410
We have an example board to do this function which you can reference here for your design:
FPD23DAEVM_User_Guide.pdf
The LVDS to parallel RGB bit mappings are the same between…
Hello Steve,
We have this board design as a reference that converts RGB (926 output) or LVDS (948 output) to DVI (HDMI). Would this work for your application?
https://e2e.ti.com/cfs-file/__key/communityserver-discussions-components-files/138/DS90Ux926_5F00_SNLU144_5F00_draft…
Hello Marc,
These two products are very similar but I would suggest DS90CF386 due to the more flexible PCLK range.
Also we have actually created the application you are describing before using DS90CF386 and TFP410. It's not orderable but you can find…
Nigel,
Thank you for your reply. If the TPS65145 should be set for voltage doubler mode on Vo3, then the reference schematic for the LC4500 evaluation board (TIDR157) on which this design is based, is incorrectly showing the device configured for voltage…
