Part Number: TPS1663 Tool/software: Hello, I was curious about safe operating area of the integrated FET for the TPS1663, especially during the in-rush current control mode.
I see that the datasheet gives Figure 7-13 as the load limit for heavy capacitive…
Hi Ignasi,
Input short is violation of device behavior so device might not work as expected and other functionalities too. I think if current would have flown from VIN to VOUT then you should have seen it limited. Does IMON voltage settles to lower value…
Part Number: TPS1663 Hello Team,
We are using TPS1663 in our application and now when we turn ON we are not getting the output voltage at the output pin.
Do we need to enable it through shut down pin through controller. Need the function of the shut…
Part Number: TPS1663 Other Parts Discussed in Thread: TPS2663 Tool/software: Is it possible to protect TPS16632 by adding a (schottky-)diode between Chip-GND and PCB-GND?
Best Regards,
Walter
Part Number: TPS1663 Other Parts Discussed in Thread: TPS25947 , TPS25946 , TPS2597 Tool/software: Hi, we're using the eFuses of series TPS2660x and TPS1663x and for our productsm normally 24V, 2A to archive PS2 level.
Did this in the past according…
Part Number: TPS1663 Hello TI Team,
I am doing simulation in Altium, Since my schematics and Layout everything I planned in Altium.
Please share the unencrypted simulation file for TPS1663 part.
Its shows error as below
Thank you,
Regards,
-Ravi.
Part Number: TPS1663 Other Parts Discussed in Thread: LM5068 , LM5067 Hi,
I want to add a short circuit protection for -60V supply. Can e-fuse be used for this kind design?
is there TI reference design available?
Thanks,
Jeff
Part Number: TPS1663 Other Parts Discussed in Thread: TPS1641 We need an efuse to protect a power line between 0V and 30V at 1A max. The minimum input voltage of the TPS1663 is given in the data sheet as 4.5V. Is it possible to power it at P_IN with e…
Part Number: TPS1663 Hello Team,
We are using TPS1663 IC for our application and which is 48V application.
Now we have used two 100uF capacitors at output but the capacitor are colliding with the mechanical components. now we have the only option to…
Part Number: TPS1663 Hi,
The following E2E forums discuss FLT/SHDN. The forum answer states that "The device doesn't assert FLT when SHDN=LOW because it is not a fault scenario."
TPS1663: internal FET ON/OFF
[Question]
After the internal…