Part Number: TPS1H000-Q1 Other Parts Discussed in Thread: INA228 , TPS2HCS10-Q1 Tool/software: Hi TI Team,
Could you please recommend a high-side switch with low quiescent current and low power consumption capable of switching on and off, along with…
Part Number: TPS1H000-Q1 Tool/software: I want to reduce the current that will be detected as an open-load for TPS1H000-Q1. At 6V min supply and max I ol,on of 8mA, a load of >750ohm will trigger an OL fault. This may result in false open-load triggers…
Part Number: TPS1H000-Q1 Tool/software: Hi Team,
We are using TPS1H000AQDGNRQ1 in our project, Customer has reported us that the IC has blown up, So we are suspecting few possibilities that could cause the IC to get damaged, few of them are below. …
Part Number: TPS1H000-Q1
Tool/software:
Hi, I have a doubt regarding inrush current limit of the IC.
we have set a current limit of 150mA typical for our application. It is mentioned that the fast-trip response time is less than 1 µs. Suppose during…
Part Number: TPS1H000-Q1 Other Parts Discussed in Thread: INA238 Tool/software: Hi,
For switching less than 300uA load, we are using TPS1H000AQDGNRQ1 high side switch, now only I notice that there is a leakage I(ol,on) in mA range. So, what I understand…
Part Number: TPS1H000-Q1 Tool/software:
below was measured on the TI EVM jumper as shown (red color on schematic image). (auto-retry mode)
Power on 25V and put add electronic load on output to GND.
The issue on FAULT signal Pin:
When Load = 0…
Part Number: TPS1H000-Q1
Tool/software:
Could you please answer my questions as follows?
#1 Is “Thermal swing” NOT equal to “Auto-Retry”?
#2 After an overcurrent occurs, but Tj does not rise, does the protection work as hiccup behavior (Auto-Retry…
Part Number: TPS1H000-Q1 Tool/software: Using the PSpice model provided by TI,
I applied a PMW signal to the input and verified that the output turned on and off according to the duty cycle. However, the simulation results showed no change in the ON…
Part Number: TPS1H000-Q1 Tool/software: In the schematic, it seems that the DELAY pin is able to be rated with 40V bias power. however, there is only 7V specified for DELAY pin in abs max. rating table.
1. Could you confirm if DELAY is able to sustain…
Part Number: TPS1H000-Q1 Other Parts Discussed in Thread: TINA-TI Tool/software: Folks,
I am trying to simulate the TPS1H000-Q1 using TI Spice.
Unfortunately the simulation will not work, it is aborted showing the following message:
ERROR(ORPSIM…
