Part Number: TPS1HB50-Q1 Hello ,
I just need to know for smartmos " TPS1HB50-Q1" when we apply load to simulate ampere value more than 6A,
then we try to control the enable PINS , actually we can't control this enable PIN any more by the controller…
Part Number: TPS1HB50-Q1 Hello,
TPS1HB50-Q1's data sheet defines some V BB voltage specs, but I'm wondering how to understand some of them.
Data Sheet Specs
Absolute Maximum Ratings
Maximum continuous supply voltage, V BB : 36 V (Max)
Recommended…
Part Number: TPS1HB50-Q1 Hi Expert
the Vol=3V, the describe of switch disabled protection as below:
I don't know why Vout exceed Vol when switch disabled. because Vol just 3v but Vout=vbat more than 3v.
also, how to enable 1Mohm?
Part Number: TPS1HB50-Q1 Hi Team,
Please find the schematic, we have seen some glitches at every power on its output.
Scope image :
Please review the schematic and scope images. Let us know what are the reason may cause this problem, Let me know how…
Part Number: TPS1HB50-Q1 Hi team,
Do we have any demagnetization capability information for the TPS1HB50-Q1?
Looking for something similar to Figure 4-5 from the following application note: https://www.ti.com/lit/an/slvae30e/slvae30e.pdf
Thanks,
Jacob …
Part Number: TPS1HB50-Q1 Other Parts Discussed in Thread: TPS27SA08-Q1 , TPS27SA08 ALL HI!
At present, there is a demand that DCDC outputs 12V voltage to charge farad capacitor (5F / 13.5V). If tps1hb50-q1 can meet the demand? Set the charging current…
Part Number: TPS1HB50-Q1 Hello Team, my customer has following question:
The B-version is specified with much higher current limit but has same Rdson as A-version. Also calculation for current limit is different. But for current sense ratio there is only…
Part Number: TPS1HB50-Q1 Hello Team, customer has following question:
1) R_ILIM resistor will be a 0603 package. Which power specification is recommended/expected for this resistor?
2) R_ILIM calculation based on datasheet:
For calculation following formulas…
Part Number: TPS1HB50-Q1 Other Parts Discussed in Thread: TPS1HC100-Q1 Hi team
Could it output ISNSFH from SNS pin @IOUT>ICL @DIA_EN=H, SEL1=L, EN=H?
Foe example, we set "ICL=2A, DIA_EN=H, SEL1=L, EN=H " and IOUT=1A, then SNS pin output ISNS=IOUT…
Part Number: TPS1HC30-Q1 Other Parts Discussed in Thread: TPS1HB50-Q1 Hi,
The customer would like to get a recommendation for the product to be applied to the DSS(Deploy side step).
Customers use it below 5A, but they need a product that is turn-off if…