Part Number: TPS1HC30-Q1 Tool/software: Hello, I am using the part TPS1HC30-Q1 (TPS1HC30BQPWPRQ1) in my design and I am working to make a footprint/3D model for the part. I am not able to find a drawing for the package, only the pre-made Ultra Librarian…
Part Number: TPS1HC30-Q1 Tool/software: Hi Team
TPS1HC30-Q1: The PWR_VBAT (VOUT) is not appearing after applying a high signal to the EN pin, while Diag EN remains low. Kindly advise on the reason for the absence of the output.
Regards,
Virali…
Hi Iain,
The first thing I notice is that the voltage you are putting through the TPS1HC30-Q1 is 24V, the nominal voltage is only rated to go as high as 18V because the TPS1HC30-Q1 is designed to support 12v automotive systems.
For your system I would…
Part Number: TPS1HC30-Q1 Tool/software: Hello,
1. If measured Current maxium is 7.5A, which current sense accuracy range should I follow?
2. In I_out = 7.5A condition, Is it possible for the Vsns voltage to equal the V_SNSFH voltage?
Is the maximum…
Part Number: TPS1HC30-Q1 Tool/software: Hello,
I've looked at the content that everyone discussed earlier, and it was mentioned that there are some parts of the Fault table in the Datasheet that need to be corrected.
When I conducted the experiment…
Part Number: TPS1HC30-Q1 Tool/software: Hello,
I am using the HS driver to drive a coil.
The current limit set is 3.5A and latch pin is set to logic high so that there is no retry during fault.
In the condition when the coil is being driven with…
Part Number: TPS1HC30-Q1
Tool/software:
Hi TI E2E,
I'm designing the RILIM value and I need to consider the power loss of the resistor.
What the KILIM value is? ( now my setting is current limit 6A; RILIM=11.3kohm; KCL=88A*kohm.)
How many…
Part Number: TPS1HC30-Q1 Tool/software: I have some doubts about the RSNS calculation. I referred to the example in the datasheet, but I'm a bit confused about two points.
KSNS=1814, but the previous specification says 1560.
The calculation in the…
Part Number: TPS1HC30-Q1 Tool/software: Hi Alan,
I think I'm right.
the voltage on VBB-VOL>Vol, can't not detect open load...
is there anything i misunderstand?
