Part Number: TPS1HTC100-Q1 Hi TI team,
My customer asked me to provide the PSPICE model of TPS1HTC100-Q1.
I could not find the PSPICE model in product web site. But please let me confirm about this again since I saw the answer comment of PSICE model…
Part Number: TPS1HTC100-Q1 Hi, What is the Inductive load max supported for the TPS1HTC100.
Planning to implement the inductive load calculation for the TPS1HTC, I need to know what is the maximum energy that can be dissipated in the case of inductive…
Part Number: TPS1HTC100-Q1 Hi,
As per the datasheet, the thermal calculation for this highside switch is out of the charts.
Say I am using for 1A and my switching rail supply is 36V, in that case, as per the Total power dissipation of the device,…
Part Number: TPS1HTC100-Q1 Hi,
For one of my application, i require a Highside switch which could act as a Form A contact to drive an external supply to the field load, load could be inductive and this will be outside my product, planning to isolate…
Part Number: TPS482H85-Q1 Other Parts Discussed in Thread: TPS1HTC100-Q1 Hello TI Team,
We are evaluating the TPS1HTC100-Q1 for a 24 V SIL-4 safety application .
Our proposed architecture uses two TPS1HTC100-Q1 devices connected in series , each independently…
Part Number: TPS1HTC100-Q1 Hi Team,
I am planning on using three of the TPS1HTC100 IC's in parallel to power my load. Each IC is powered by a separate battery. I plan on placing reverse blocking diodes at the VS of each IC as a protection mechanism…
Part Number: TPS1HTC100-Q1 Hi,
I am using the ic in auto retry mode (latch is not connected) so after how much time will the retry of the ic occur ? And after getting out of the latch mode does it go to active mode or standby mode ?
Part Number: TPS1HTC100-Q1 Hi Team,
I am using the TPS1HTC100 IC as my smart switch, and was wondering if it can have bidirectional current flow. What would be the effects if I were to have a higher voltage than V_S at the output of the smart switch…
Part Number: TPS1HTC100-Q1 Hi Team,
My current setup includes a power supply of 53V, a load bank to draw 209W of power from the smart switch(TPS1HTC100). After some time the ic went into current limiting and then never turned on. I must have probably…
