Hi John,
I don't think TVS part will help much as the abs maximum of the device is 6V and the clamping voltage of this device is 15V. On evaluation, if it is reducing the transients then that is good.
Best Regards, Arush
Part Number: TPS22948 Tool/software: As mentioned in the datasheet, FLT PIN is to be pulled low during thermal shutdown or reverse current protection.
Can we leave the FLT pin open? or It needs to be given as pulled low or pulled up?
If I leave it as…
Part Number: TPS22948 Tool/software: We are working on a wearable device project where we we are using wireless charging system. Wireless receiver IC is LTC4124. Now We want to control this TPS22948 load switch from this CHRG status Pin. Without using…
Hi Marco,
Sorry for the delay - we don't test IEC 61000-4-2 Level 4 ESD on TPS22948. Can you achieve this standard with an external component like a TVS diode?
Thanks,
Patrick
Part Number: TPS22948 Other Parts Discussed in Thread: TPS22950 Hello--because of the global parts shortage, we are searching for a possible replacement for TPS22948DCKR that is in stock. Can you make a recommendation?
Part Number: TPS22948 Hello,
We've used the TPS22948 switch for the HDMI 5V Output circuit.
It operates normally and turns on and off according to the EN pin but we encountered a problem - when the EN pin is low (meaning the switch is not conducting…
Part Number: TPS22948 Hello
The datasheet says 18nF at the output pin is optimal, but my application would have the load capacitance of 1uF or possibly 2u2 at the output pin. Is it permissible to do this, and can you tell me what effect on operation this…
