Part Number: TPS22953-Q1 Other Parts Discussed in Thread: TPS22953 , LMR14030 , TPS62813 I have used two TPS22953s for output shorting, with the chip enable controlled by MOSFETs for switch selection. The initial intention of the design was to implement…
Hello Timothy,
Only the output pin is capable of Short to bat protection. But it will be seen in Input pin if I'm not wrong. I need protection for input side when short to bat happens in output section is this feature available in the device which you…
Part Number: TPS22953 I am using TI part TPS22953DQCR. The EN pin is supposed to have <0.1uA of leakage current. I thought that meant I could safely use a 357k (high side) and 100k (low side) resistor divider network on the EN pin. I learned that those…
Part Number: TPS22953-Q1 Hi
I'm Sandra, Design Engineer at Tessolve Semiconductor, India.
We are currently in need for an automotive Load switch with current rating 10 Amps or greater for our automotive design.
Identified a TI part “ TPS22953…
Part Number: TPS22953-Q1 Hello Team,
I would like to know tdelay and tramp values at Vout = 1V, Iout=5A without Ct.
If I understood well, total delay from EN to Pgood would then be td+tr, is that correct ?
Thank you for your support !
BR,
Matisse
Part Number: TPS22953 Hi, TI expert.
The customer is reviewing the application of TPS22953, a LOAD SWITCH, for Super-CAP (5V/10F) charging.
I want to control the V-OUT slew rate through the CAP capacity control of the CT pin of the TPS22953 to prevent…
Part Number: TPS22954 Other Parts Discussed in Thread: TPS22953 Hi Team,
I have a customer using our TPS22954 and they are asking if it is possible to use the TPS22953 as an alternative to have multiple options for their production. Below is customers…
Part Number: TPS22953-Q1 Hi Team,
When TPS22953-Q1 is enabled, if the output terminal is connected from other power sources, can it still prevent backflow?
Part Number: TPS22953 Other Parts Discussed in Thread: TPS22950 Hi Team,
I have three questions about TPS22953:
1. Does TPS22953 have over current protection feature, if yes, what's the limited current value (5-A Maximum Continuous Switch Current)…