Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TPS22969 Other Parts Discussed in Thread: TPS22959 , , TPS22962 Hi support team.
I have received some questions from my customers regarding TPS22969, TPS22962 and TPS22959 as described below.
1. Since the three products differ only in the absolute…
Part Number: TPS22969 Dear Specialists, Customers need FMEA information to adopt new parts. Please tell me the FMEA information of TPS22969. It helps in design-in.
Best regards, Yusuke
Part Number: TPS22969 Hello,
I have a question regarding inrush current limiting - does it exist on this component?
My input is 5V, with output capacitance of 500uF. current 1.6A continuous.
Will it be ok?
Can I use the Vout rise time to calculate the…
Part Number: TPS22969 we have used TPS22969 load switch for one of our design , this design requires a specific power on sequence, while probing the output of the load switch we found that the there Is 1.8V present at the output pin even when the enable…
Part Number: TPS22969 Other Parts Discussed in Thread: UCD90160 Hi, We are using TPS22969DNYT device in our board. Please see the attached for our schematics. While testing our board, we are seeing around 1.5V as VOUT even without enable(control) signal…
Part Number: TPS22969 Other Parts Discussed in Thread: TPS22915 I am looking to use a high side driver such as the TPS22969 to cut power to raspberry pi. Looking for potential alternative parts to do the job. this one is sized at 6A, so it would work,…
Part Number: TPS22969 Other Parts Discussed in Thread: TPS22990 , Hi,
i am using above switch in the power supply section.
Can VBIAS and VIN be same as 5V? Is there any issue for that.
I have only one supply available.
Part Number: TPS22969 Hi there,
As the picture below shows, the output cap is 100 times smaller than the input cap.
Just want to make sure if that's OK.
Thanks!
Best regards,
Roy Hsu
Part Number: TPS22969 Other Parts Discussed in Thread: UCD90160 Hi, We are using TPS22969DNYT device in our board. Please see the attached for our schematics. While testing our board, we are seeing around 1.5V as VOUT even without enable(control) signal…
Part Number: TPS22969 Hi,
We would like to control the power of a GSM module to reduce its power consumption during power-off mode (approx. 30µA)
We looked at the TPS22969, but we have a question about the output capacitance. To reduce the voltage…
