Part Number: TPS2394 Tool/software: Good afternoon.
We have used your hot swap power manager circuit TPS2394PW for about five years. We use it for controlled voltage start-up and over-current protection for our negative 15V DC supply. (And TPS25921LDR…
Part Number: TPS2394 Hi team,
My customer considered to design this part but they don't want to use external Sense resistor for cost up.
So if they remove Rsense and short Sense pin and Source pin together, is it ok?
Any side-effect here?
Please…
Part Number: TPS2394 Other Parts Discussed in Thread: TPS2350 , TPS23521 , LM5067
I have a few questions on TPS2394.
For the design tool which is titled by "slvc064a. TPS2350_DesignCalculator_RevA",
Q1. there is a note - that is "TPS2350/TPS2394…
Part Number: TPS2394 Hello
I need Design Calculator Tool of TPS2394.
I'm not found the Calculator Tool on TI Site.
Could you Provide Design Calculator Tool of TPS2394?
Best Regards
Other Parts Discussed in Thread: TPS2394 , LM5067 , LM5068 Hello,
I was testing TPS2394 on evaluation board und have several questions about that hot swap controller.
Conditions: Vin=-24V, Cflt=4.7µF, Cramp=1µF, Rsense=4mOhm, Cload=47000µF, Rload…
Other Parts Discussed in Thread: TPS2394 Hello,
I’ve got TPS2394 in my design whose behavior is different to evalboard.
They have also slightly different labels:
on Eval-Board: TPS2394 05KG4 D5LO
In Design: TPS2394 23K04 ALLR.
I’ve changed…
Hi Brian,
TPS2662 does not support negative volage rail operation.
Please have a look at negative hotswap controller devices, TPS23521, TPS2394, LM5067.
Regards,
Kari.
Hi Mahesh,
This design may push the limits of the TPS2350 hotswap controller. We have a spreadsheet tool which can help you perform the evaluation normally available via the TPS2350 product page (but right now, the TPS2350 page seems to be having issues…
Patrick,
TI has a number of hotswap ICs that will handle 12v/15A. The TPS24700/01, TPS24710/11, TPS24720 can do this and have EVMs build for 25A applications that are easily scaled as you need. Please see www.ti.com/hotswap for selection and design…
Hello,
The UCC3806 is a dual output controller though it can be used in a flyback where only one of the outputs are used to drive the switch it might be better to choose a single output controller. Look at page 46 of the attached under General Purpose…
