Hi,
I apologize that no one has followed up with your question. I'm going to close this thread, but if you still have a question please feel free to post a brand new thread instead of replying to this one. We will do our very best to respond within…
Other Parts Discussed in Thread: TPS2412 Hola,
We set jumper as below figure for TPS2412/13 EVM and we found that the support current of the right side is more than about 1/3 to the left side！
Is this about the circuit design or any else to cause…
Other Parts Discussed in Thread: TPS2412 , TPS2413 Hello,
My customer have a question about TPS2412.
When VDDpin and Apin is 4.0V, What is the voltage range of Gate positive drive voltage, V(GATE-A)?
I looked at the data sheet, but there is not…
Other Parts Discussed in Thread: TPS2412 , TPS2413 We are test EVM board and try 3 pcs sample. MOSFET Rds (on) as bellow.
Test result as bellow :
Why S1 and S2 fully turn on when 1.55A
S3 fully turn on when 1.4A
EVM sample fully turn on when…
Other Parts Discussed in Thread: TPS2412 , UCC39002 I have a new request from key customer about load sharing (two power sources 12V/12A).
More precisely, customer would TI to confirm attached schematic is applicable.
Questions list:
Does the…
Other Parts Discussed in Thread: TPS2412 Hello Experts,
From TPS2412 demo board schematic, I saw that there had a filter capactior between pin 6 & 7.
1. Any recommended value (or capacitance range) of this capacitor or it depend on PCB layout? …
Other Parts Discussed in Thread: TPS2412 Hello,
Can we use tps2412 as power selector to select 2 power source PSU 1(12V and PSU2(12V)? PSU 1 as main source, when PSU 1 lost, PSU 2 will take over. it's not sharing, use either PSU 1 or PSU 2
MD
We do not have an output bulk capacitor.
Right now I am using 33K Rset resistors and with a 25 ohm load @ .2A I am not getting the sawtooth. With 0 ohm load then it comes back. I will try out the 100k ohm and see if that works as well.
We do not…
Other Parts Discussed in Thread: TPS2412 , UCC29002 , TPS56221 , LM5050-1 I used Webench for a TPS56221 design and would like to use 2-3 of these in parallel. I have read what I could find on the site so far and determined I should use the UCC29002/1…
