Part Number: TPS24710 Other Parts Discussed in Thread: TPS24720 Hi,
I don't understand the meaning of "any series resistance between Css and the Gate pin" which is mentioned in the application report "Using Soft Start with TPS2471x and TPS24720". So…
Part Number: TPS24710 Other Parts Discussed in Thread: LM25061 , TINA-TI , TPS24701 Dear All,
I have an application where I need to limit the rms value to the load to 0.8A @5V.
I wonder if an hot-swap controller as for instance the TPS24710 could…
Other Parts Discussed in Thread: LM5060 , LM5069 Team,
I'm now promoting TPS2471x for a system switch with inrush protection between system and battery.
However, generally power switch has very large Isd, so the customer does not use it unless a…
Other Parts Discussed in Thread: TPS24710 We just received a new board with this HSC and I have a problem with it.
The bottom line is that Vout = 9V while Vcc is 12V due to the fact that the gate is not fully open .
I’m measuring on FLT_b = 2.8V,…
Part Number: TPS24710 Other Parts Discussed in Thread: TPS24711 Hi,
Could you please tell me how to change the start-up delay and the ramp-up time when pulling EN pin to high during the power-on as the following timing chart ? We would like to decrease…
In the datasheet Rev F, the description about capacitor between GATE and GND was deleted. I would like to know this reason. If the customer sets this capacitor, is there any concern about device operation?
Best Regards,
Kohei Sasaki
Other Parts Discussed in Thread: TPS24710 HI community!
Does the TPS24710 have a thermal pad? The EVM user guide and data sheet are unclear and the data sheet only mentions that the part has a thermal pad in the layout considerations.
Thanks for…
Other Parts Discussed in Thread: TPS24710 Hi all!
There is a current limiting circuitry using TPS24710DGS in the attachment file.
Requirements are:
Voltage: 10.8V to 13.2V
Ilim Current: 50 mA, Rsense = 510 mOhm.
However real current limit is…
Other Parts Discussed in Thread: TPS24710 Hi all!!!
Below is shown a current limiting circuitry using TPS24710;
Requirements are:
Voltage: 4.9V to 6.0V
Current: 6 amps
Anyone can please review this design and confirm whether it will work for…
Part Number: TPS25947 Other Parts Discussed in Thread: TPS2640 , TPS24710 , TPS2490 Dear Friend
I need a load switch to provide an over-current protection between 100 mA to 500 mA and set based on applications, which means the load switch must be able…
