Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TPS2492EVM-003 Other Parts Discussed in Thread: TPS2492 , We are developing a design featuring the TPS2492 and have purchased an Evaluation board (TPS2492EVM-003) to characterise the IC while we are developing the design.
We are seeing some…
Hi Konstantin,
Yes, I used TPS2492EVM-003
At no-load, OVLO recovery is independent of Vrog and timer setting. Since it is not recovered at no-load on your board, I suspect it as system/setup issue and not the device issue.
Please evaluate on the EVM you have…
Part Number: TPS2492 Hello,
I'm using TPS2492EVM-003 and I was measuring nPG delay in case of disabling the output through UVEN.
The datasheets was not very straightforward in this regard, it only explainis a deglitch delay of 9ms in case of over…
Part Number: TPS2492 Other Parts Discussed in Thread: , TPS1663 Hello,
Firstly, just a quick comment that the Design Calculator for TPS2492 is missing the Overvoltage currently, so while an Undervoltage (UV) Resistor is recommended, no Overvoltage (OV…
Part Number: TPS2492 Other Parts Discussed in Thread: CSD16401Q5 Hello,
I've been using the TPS2492EVM-003, and exploring the option of placing and extra RC over the gate to get a soft start (positions R11 and C4). R11 is 1k as is suggested in datasheet…
Part Number: TPS2492EVM-003 Other Parts Discussed in Thread: TPS2492
Hi TI Team,
I have a problem with turning mosfet off in current limiting mode.
I am using the evaluation board TPS2492EVM-003 with some differencies : Vin=28V, Rsense=10mOhm, Ilim=5A…
The circuit seems to be working as expected. When the short is applied, the TPS2492 goes into current limit and the timer starts. You can see the current being regulated at the IMON pin as Vimon/Gain/Rsense or 2.4V/48/0.01 = 5A for approximately 15ms…
