Thank you for update. Please let me know if you have any question. I will be closing this thread. You can always reply back here or open new thread.
Best Regards, Arush
Part Number: TPS2521 Other Parts Discussed in Thread: TPS2660 , TPS1641 Hi team,
Customer is evaluating TPS2521 in their project. They like the Timer feature, that could let the current goes above limit for a setting blank time.
However their target limit…
Part Number: TPS2521 Hello,
I'm considering a TPS25210 device and have a question about the DVDT pin. CdVdt is connected to DVDT, but what effect will it have if it is shorted to GND? In the case of floating, there was a description that SR is the…
Part Number: TPS2521 Other Parts Discussed in Thread: TPS25947 Hi,
My customer design condition is input voltage 3.3V, output current 2.4A, Ta is 25 degreeC.
I checked DS the ON resistance is 31mohm and 50.2mohm with different condition, would like to…
Part Number: TPS2521 Hello,
I am doing constant calculation of TPS2521 using the attached document. (Question 1) RILM on line 54 is automatically calculated, but is it calculated from IMAX on line 18? The result is different from the calculation using formula…
Part Number: TPS2521 Hello,
I have a question regarding the Design calculator for the TPS2521. (Question 1) Regarding the calculation formula of formula 9 (CdVdt) on page 34 of the data sheet, is the value 2000 assigned to it a fixed value? Also, in the…
Part Number: TPS2521
Hello,
I have a question regarding the junction temperature of the TPS2521. The maximum rating of TJ is described as "Internally Limited", but what is the actual temperature? Thermal shutdown is 154°C. lower than that?…
Part Number: TPS2521 Hello,
I am using EVM to measure the output slew rate. Set SR=2V/ms. The results are in the table below. As the amount of current increases, SR decreases. Is this result correct? If so, please tell me why the SR changes.
Best regards…
