Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TPS25921A Other Parts Discussed in Thread: TPS25921L Hello,
Could you please tell us the difference between TPS25921A and TPS25921L?
Thanks,
JH
Part Number: TPS25921A
Tool/software:
Hello,
I'm trying to use the TPS25921A to limit the inrush current for one of my USB powered projects.
As far as I was able to read on the internet the USB 2.0 spec defines the maximum load as R=44Ω in parallel…
Part Number: TPS25921A Other Parts Discussed in Thread: TPS2595 , TPS2597 , TPS25961 , TPS2596
Dear Team,
Do we have any solution can replace TPS25921A?
Is TPS259541DSGR can replace TPS25921A?
Thanks a lot.
Jimmy
Part Number: TPS25921A Other Parts Discussed in Thread: TPS2597 Hi Team,
My customer is using TPS25921A and controlling ENUV pin with CPU.
In TPS25921A's config, /FLT will be pulled to LOW when Low signal is added to TPS25921A's ENUV pin.
Customer…
Part Number: TPS25921A A 5V, 1A wall adaptor powers the system through a 2meter cable attached before C48. The output load is very light, typically less than 100mA.
At power-up with ILIM connected to 100K, the IN pin has a periodic glitch, about ever 1msec…
Part Number: TPS25921A Hi Team,
My customer is using TPS25921A for 5V USB protection.
Now USB device is connecting to the port and if they turn on power, 2~3A inrush current flows through for 100~200us.
In this case, FLT pin will activate, is it correct…
Part Number: TPS25921A Other Parts Discussed in Thread: TPS25921L , TPS25982 Dear Specialists,
My customer is considering TPS25921A and to use in parallel.
According to the application note(SLVA836), TPS259241 is possible.
http://www.ti.com/lit/an/slva836…
Part Number: TPS25921A Other Parts Discussed in Thread: TPS2490 , TPS2596 , , TPS2595 My customer now uses ac-dc12v to supply power to the system. The current of DC12V can be brought to 2.5A. The 12V of the system will supply power to external sensors through…
Part Number: TPS25921A Dear expert,
My customer is looking for an E-fuse solution that can shut off with 400mA for 50ms. Please share your suggestions, thanks.
Part Number: TPS25921A Hi,
My application requires eight electronic fuses whose current limits can be dynamically set by an MCU to between 0.8A and 1.2A.
Rlim @ 0.8A = 76.8kOhm
Rlim @ 1.2A = 115kOhm
My current proposal is to use a 76.8kOhm fixed resistor…
