Part Number: TPS25923
Tool/software:
Hi Team,
In one of our projects, we are using the following IC for protection purposes at the input side of the CCA:
TPS259231DRCR - IC Electronic Fuse 8% 10VSON - Texas Instruments
However, during some field…
Part Number: TPS25923 Other Parts Discussed in Thread: TLV62595 , TPS2597 Dear Team,
Hope you are doing well.
I got a question from the customer during the use of TPS25923.
The typical overvoltage clamp of TPS25923 is 6.1V and can reach to the…
Part Number: TPS25923
After I read the document, Ihave some question about efuse.
Question : I_fastrip accuracy formula in calculation tool. What is source of 20%. I couldn’t see the related information in datasheet.
Question : Meaning of I_fastrip…
Part Number: TPS25923 Other Parts Discussed in Thread: TPS25982 , TPS25910 Hi Team,
I have a question about the output voltage of efuse. My customer is using an DC/DC (12V to 5V) in front of efuse. The Vin suddenly occur noise and then it will cause…
Part Number: TPS25923 Hi, Could you tell me about the response speed of over voltage clamp. How fast does this device perform this clamp operation after exceeding the overvoltage (typ6.1V)? For example, is it possible to clamp spike noise of 100ns? Best…
Part Number: TPS25923 Hi everyone,
I'm using your product in order to switch the power for Asus Tinker board.
Without Asus board, it works properly. However, when connected Asus board, there are around 1.5V at the output although IC (EN pin is 0V…
Part Number: TPS25923 Other Parts Discussed in Thread: TPS2595 , TPS25200 Hello,
In datasheet figure 4, 10mA means Iout=10mA. Is my understanding correct?
We would like to set Vovc voltage less than 6V. Is there any way to set lower 6V?
How does…
Hi Louis,
What is the max. load current on 3V3?
Looks like the device is fast-tripping. First try using DV_DT cap between 470pF to 1nF at pin '1' of TPS25923, if it did not solve, then set the turn-ON voltage of TPS6209733 at 4.4V using resistor divider…
Part Number: TPS25923 Hello,
Below is TPS259231 maximum rating and waveform. VOUT is varied by VIN. But if customer do hot swap, VOUT will be discharged slowly to VIN and maybe will cause VOUT over VIN 0.3V. Does it have damage risk by this condition…