Part Number: TPS25946 Other Parts Discussed in Thread: TPS25947 Tool/software: Hi TI Team,
I’m currently using the TPS25946 to implement a backup battery switching function. Please see my schematic below:
In the circuit:
The upper section…
Part Number: TPS25946 Tool/software: Hi All,
I have a question about IEC62368.
TPS25946 is IEC62368 certified.
If IEC62368 has been obtained for eFuse, can we say that the application in which it is installed has also been certified for IEC62368?
Or…
Part Number: TPS25946 Tool/software: Hi TIer
Currently we are promote our TPS25946 to customer, I see the Inrush capability in datasheet is depends on different application condition.
So How can I describe our SPEC to customer in quantitative analysis…
Part Number: TPS25946 Other Parts Discussed in Thread: TPS25981 Tool/software: Can two TPS25946 switches be used in parallel, with identical settings for EN/UVLO, OVLO, ITIMER, dVdt, ILM and PGTH?
We intend to connect our system's primary battery connection…
Part Number: TPS25946 Tool/software: To whom it may concern,
I am reaching out on behalf of my employer to request a letter of volatility (LOV) for part TPS25946. The LOV will be used to develop sanitization procedures for hardware which this part is…
Part Number: TPS25946 Tool/software: To whom it may concern,
I am reaching out on behalf of my employer to request a letter of volatility (LOV) for part TPS25946. The LOV will be used to develop sanitization procedures for hardware which this part is…
Part Number: TPS25946 Tool/software: Hi,
I'm looking for an over-current protection device for DC motor application where the output voltage is between 0V-30V (no negative voltage/reverse current). can I use one of the e-fuses such TPS25946 for this…
Part Number: TPS25946 Other Parts Discussed in Thread: BQ2980 Tool/software: I have a rechargeable battery load switch application where I plan to connect Single Cell Lithium (~4.2V, 2A Max) Battery to "TPS25946_IN" and BatteryCharger/PMIC to "TPS25946_OUT…
Part Number: TPS25946
Hello,
We are using the TPS25946 e-fuse. The input voltage is 12V. I am attaching a screen shot of the circuit.
Initially, we were using a 0.01 UF capacitor at the input of DVdt. We could observe that occasionally (often), the…