Part Number: TPS25983EVM Other Parts Discussed in Thread: TPS25982 , TPS25983 HEllo;
We have designed a device that uses the TPS259830ONRGER for short circuit protection.
We have found it is not stocked at main retailers.
Is there a drop in replacement…
Part Number: TPS25983EVM Other Parts Discussed in Thread: TPS25983 , Hello,
I am testing an eFuse part TPS25983 to evaluate how can it be used in our product design.
I have an evaluation board TPS25983EVM.
While running the “Output Hot Short” test…
Part Number: TPS25983EVM Other Parts Discussed in Thread: TPS25983 , TPS25982 Hello;
I am wondering on how this part handles the below two scenarios;
Device is not powered --> Output has short circuit --> Power is applied
Device is powered --…
Part Number: TPS25983EVM Hi
Input: 12V
Output:12V Issue: The output cannot start up when the load exceeds 12V / 0.6A. Even after removing the output capacitor, the issue remains. It seems protection is triggered during startup current. Is it correct…
Part Number: TPS25983EVM Tool/software: Hi team,
My customer tested OCP function on the EVM. Setting config as below.
J9 set to 2mS
J11 set to NO retry
J10 set to 2A
Customer's load is 2A/ 4ms~ they want to detect OCP 2A and 2ms then shut down…
Part Number: TPS25983EVM
Tool/software:
Hello,
Does TI have any test results for this EVM using Vin=24V?
Also - are the design files available - appears to be done in Altium.
Thanks In Advance, John W.
Part Number: TPS25983EVM Other Parts Discussed in Thread: TPS25983 Tool/software: Hi,
I'm planning on using the TPS25983 on an upcoming design and am looking at the EVAL board for a good example of placement and routing. However, I can't seem to find…
Part Number: TPS25983EVM Tool/software: In the User's Guide for TPS25983EVM, on page 11, Figure 3-1, there is a part called NT1 in the lower left corner, but it is not listed in the parts list on pages 14 to 16. What is NT1? Could you teach me what parts…
Part Number: TPS25983EVM Hi team,
The datasheet only shows top/bottom layers of PCB image. I think there should be internal layers because I can't find routing from ILIM, ITIMER pins etc. to headers(J9, J10 etc.). Also, GND plane of the IC looks floating…
