Part Number: TPS2663 Tool/software: Hello,
I am planning to use the TPS26630 in parallel as my load current is more than 6A. I would like my system to be protected from reverse polarity but i also want to control the load ON/OFF using the SHDN pin.…
Part Number: TPS2663 Other Parts Discussed in Thread: TPS1663 , Tool/software: I am trying to design a device that can power a number of NEC Class 2 rated circuits from a single 480W power supply at higher voltages ~60V or even 48V. I have been unable…
Part Number: TPS2663 Tool/software: We are observing that the TPS26630RGE effuse IC misbehave in one of the device.
Issue : after applying power 1 st time device is powering on properly, but when we try power off and on again the device is not drawing…
Part Number: TPS2663 Tool/software: Questions about TPS26631 in the TPS2663x series.
Inrush current occurs when [External power supply input voltage is suddenly increased].
The inrush current causes the overcurrent protection (OCP) to operate, which…
Part Number: TPS2663 Other Parts Discussed in Thread: TPS2662 , TPS2660 Tool/software: Hi, This is a question about protection in case of reverse power connection. The power return is connected to FG by R1 and must be disconnected when reversed. I am…
Part Number: TPS2663 Tool/software: Hello
We have included the TSP26633 in a design.
During our initial board bring-up, we have tried to perform over-current tests on the board to verify that the TPS26633 shuts down the current to the rest of the…
Part Number: TPS2663 Other Parts Discussed in Thread: TPS2662 , Tool/software: In the US-35180-UL certificate for IEC 62368-1:2014 compliance, the stated ratings are as follows:
TPS26630, TPS26631, TPS16630 Input Voltage: 4.5 - 60Vdc Output Continuous…
Part Number: TPS2663 Tool/software: Hi team,
Why does NC pin at pin19 and pin24 are respectively tied to OUT and IN in TPS26630-33EVM?
My understanding is NC pin is recommended to tie to GND for heat dissipation, so I assumed pin19 and pin24 is also…
Part Number: TPS2663 Tool/software: Hi,
We are using the EFUSE circuitry in our design (attached in zip). The L6 part used is XAL5030-332MEC as suggested by TI for input EMI Filter (Figure 1).
Kindly suggest if XGL5030-332MEC alternate part can be…
Part Number: TPS2663 Other Parts Discussed in Thread: TPS1663
Tool/software:
Hi,
I'm trying to simulate this component TPS26630RGER in LTSpice
But I keep getting error saying "too few nodes "
how can I fix this as this simulation is critical…
