Search tips
Showing 15 results View by: Thread Post Sort by

  • TPS2834: Regarding TPS2834,TPS2835 and TPS51601A

    TI Thinks Resolved
    Part Number: TPS2834 Other Parts Discussed in Thread: TPS2835 , TPS51601A Dear TI team, Good evening. We need half bridge gate driver which supports 2Mega Hz switching frequency, 20V Vgs(gate to source voltage) and Maximum 1.2A output current support…

  • TPS2834: Thermal Pad Connection

    TI Thinks Resolved
    Part Number: TPS2834 Hello Team, My customer would like to confirm if they could connect thermal pad to GND plane or not? Regards, Renan

  • RE: TPS2834: Follow up to issues " TPS2834: Low side of MOSFET driver not operating at all when in synchronous mode and using in full bridge configuration. External modification had to be performed in order to get this working."

    Hello Adam, Thank you for the schematic. After reviewing the datasheet it looks like you can accomplish what you desire by your proposed circuit. From the datasheet specs on the DT pin it looks like you need to guarantee a high of >2V and a low of …
    • Answered

  • TPS2836: Which one is better for Sync buck MOSFET driver between TPS2836 and TPS2834

    Resolved
    Part Number: TPS2836 Other Parts Discussed in Thread: TPS2834 Hi TI EE: I want to design a Sync buck power .I my case,Vin:24V,Vout:12V~24V.fsw:300KHz. I have trouble to choose the driver IC,please help to make sure which one is better between TPS2836…
    • Resolved

  • RE: TPS2834: Low side of MOSFET driver not operating at all when in synchronous mode and using in full bridge configuration. External modification had to be performed in order to get this working.

    Hello Adam, I work with Don as an applications engineer, and will comment on your 3 proposed solutions. If you have the 1st solution working, pulling down the bridge voltage with a resistor, I would suggest that as a primary solution. Grounding…
    • Answered

  • Resistance junction to board

    Resolved
    Other Parts Discussed in Thread: TPS2834 Good morning, would be possible to know the value of the resistance junction to board of the following part numbers: - CD74HC4067M - TPS2834PWP - SN74AHC74PWR I was not able to find it in the datasheet…
    • Resolved
    • Answered

  • RE: TPS2836: Input control options

    Resolved
    Hello Anthony, Thank you for the interest in TI gate drivers. I reviewed the datasheet for the TPS2836, and I don't see an input that will result in the high and low side drivers in the off state. There is a similar driver, with higher pin count which…

  • RE: Looking for sync buck MOSFET driver

    Dear sir, I would like to use IC TPS2834 in lead acid battery charger with solar MPPT applications specifications are output voltage is 14.2V max 10A current rating solar panel voltage is min 20 to max 48V Can i use this IC as mosfet driver for…

  • RE: TL5001 Specification Questions

    Generally speaking, TPS2834 and TL5001 are really old devices. You are pretty much limited to what is in the datasheet for resources. The original IC designers are long since retired from TI. I can make some comments though. Those caps should be non…
    • Answered

  • RE: UCC3806 reference design and simulation model

    Resolved
    Hello, The UCC3806 is a dual output controller though it can be used in a flyback where only one of the outputs are used to drive the switch it might be better to choose a single output controller. Look at page 46 of the attached under General Purpose…
    • Power management guide 2011.pdf

Didn't find what you are looking for? Post a new question.