Part Number: TPS2H160-Q1 Tool/software: Hi Expert,
Have a nice day!
For TPS2H160-Q1, “ Note that if using a GND network which causes a level shift between the device GND and board GND, the CL pin must be connected with device GND .”
What I understand…
Part Number: TPS2H160-Q1 Tool/software: Hello,
we are using the TPS2H160 in the following conditions:
OUT1 and OUT2 connected in parallel
output load = 160 uF
Vbatt = 32V
repetition = 1 per vehicle key cycle
lifetime = 29251 key cycles …
Part Number: TPS2H160-Q1 Tool/software: Hi team,
Do you know how to set the current limit point for each channel?
The specification mentions current limiting, but is this the total current of the two channels combined, or is it an independent…
Part Number: TPS2H160-Q1 Tool/software: Hello,
For one of our projects, we are looking for an integrated circuit that can provide at least 1A output per channel to control LEDs and can operate at both 12VDC and 24VDC. Current sensing is also one of…
Part Number: TPS2H160-Q1 Tool/software: Dear support,
I have a couple of questions regarding the output leakage currents specified in the datasheet, specifically I(ol,off) and Ilkg(out), which are defined under different conditions.
- I(ol,off) is…
Part Number: TPS2H160-Q1 Tool/software: Hi Team,
May I know whether I can connect the NC pin to GND?
Datasheet only mention that it's not internally connected.
Not sure whether we can do that.
If we connect the NC pin to GND, do you have any…
Part Number: TPS2H160-Q1 Other Parts Discussed in Thread: TPS4H160-Q1 Tool/software: Hi Expert,
Have a nice day!
For TPS2H160-Q1, “ With a GND network, tie the thermal pad as one trace to the board GND copper. ”
My questions:
Is the trace…
Part Number: TPS2H160-Q1 Tool/software: Dear team,
Would you help me to answer 2 topics below about internal oscillator of TPS2H160AQPWPRQ1?
1. What is the frequency of it?
2. How is it used? I believe one is used for charge pump, but any other…
