Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TPS3306-Q1 Tool/software: Hello
I wanted to use the above for monitoring +5V and +3.3 V to my DSP.
Hence selected the --33 Version.
If I choose Vdd as 5V, Sense1 is connected to +5V and Sense2 to +3.3v
/RST pulled up to 3.3V & is going to…
Part Number: TPS3306 Can you tell me what the max junction temperature rating is for TPS3306-18D and the case to junction resistance? These are not specified on the datasheet.
Part Number: TPS3306 there is a confusing about PFI and PFO behavior.
In the block diagram, when the PFI is greater than 1.25V ref. voltage, the /PFO pill is active low, correct?
Part Number: TPS3306 Hi,
I am using TPS3306 for monitoring 3.3V and 1.8V.
I am using external resistor divider at pin SENSE1(3.07V), and SENSE2(1.76V) to setup the threshold.
In the datasheet there are internal resistors R1, R2, R3 and R4 used at the …
Part Number: TPS3306 Hi Team,
My customer do not want TPS3306 output reset signal during processor start up stage(that means they want to disable watch dog during processor start up stage), we know that if float TPS3306`s WDI pin will disable watch dog…
Part Number: TPS3306-Q1 Other Parts Discussed in Thread: TPS3306 , SN74LVC1G125-Q1 Hello, Our project uses the TMS5703137DZWTQQ1 microcontroller with a supply supervisor/watchdog IC TPS3306-25QDRG4Q1. The nRESET output of the TPS3306 is connected to the…
Part Number: TPS3306 Other Parts Discussed in Thread: SM320F28335-EP Hi TI AE,
I have a few questions on the voltage tolerances of each device (MCU, Watchdog IC, and LDO) all from Texas Instruments. It seems that we have wide tolerance on the TPS3306…
