Part Number: TPS3430-Q1 Other Parts Discussed in Thread: TPS3430 Tool/software: Hi,
Already discussed the reset issue under that thread
"TPS3430-Q1: Watchdog random reset with external debugger"
Still the reset issue not resolved, is it possible…
Part Number: TPS3430-Q1 Other Parts Discussed in Thread: TPS3430 Tool/software: Hello
we are using this TPS3430 as windows watchdog with CYT2B74 MCU(5V),
but whenever we connect the debugger/ winades tool at the JTAG_RESET connector for debugging or data…
Part Number: TPS3430-Q1 Other Parts Discussed in Thread: TPS3430 Tool/software: Hi expert,
Is there any concerning points when TPS3430-Q1 use in that once Vdd down 1.6V
Is there any other voltage conditions that need to be met after falling below 1…
Part Number: TPS3430-Q1 Other Parts Discussed in Thread: TPS36-Q1 Tool/software: Hello Expert,
Could you please tell me when TPS3430-Q1 start count down of WD first pulse if pin is configure as WD=Enable at power-up?
Timing Diagram as X duration at…
Part Number: TPS3430-Q1 Tool/software: Hello Expert,
Could you please tell me pin status of WDO(pin8) during power is off?(e.g. Hi-z short-to-GND, weak pull-down, etc)
Our customer want to know this information for estimating abnormal condition's circuit…
Part Number: TPS3430-Q1 Tool/software: Hi Team,
In the datasheet, '8.2.2.1 Design Requirements - Design 2' mentions the maximum device current consumption. The max current is 200uA according to the design requirement, but in the design result the current…
Part Number: TPS3430-Q1 Tool/software: Hi team,
My customer has 2 questions regarding TPS3430-Q1's pin connection, can you help advise?
1. Are the SET0 and SET1 pins open-drain outputs? Do they need to have pull-up resistors when connected to a high…
Part Number: TPS3430-Q1 Hi team,
I've got several basic questions about WatchDog Timer, including:
1. When to use Internal WD, and when to use external WD? Why?
2. The key spec of WD Timer that customer pays attention to
Thanks a lot for your help…
Part Number: TPS3430-Q1
Hi, Support Team
our client have a question is Why WDO pin always is High status?
schematic:
Power on default waveform:
command output off:
command output on waveform: why WDO status is keep High? is should be to Low status…
Part Number: TPS3430-Q1 Other Parts Discussed in Thread: TPS3430 , Hi, Support Team
TPS3430_LHM_WDI have 3.3v, LHM_WDO_OUT will keep low.
if TPS3430_LHM_WDI dont have 3.3v, LHM_WDO_OUT will turn to Hign
schematic as below chart: have any concern?
also…
