Part Number: TPS35-Q1 I am using TPS35AA38AGADDFRQ1 as watchdog reset IC in my design. Below is schematic.
Crst=100nf, trst= 500mS.
Twd= 6.66Sec.
I am expecting reset pulse of 500ms after every 6.66 sec in case software freeze. It is happening properly…
Part Number: TPS35-Q1 Dear team,
I have doubt with start up delay functionality. As per datasheet, on page no. 19, it is mentioned, "The tSD frame is not initiated when the watchdog functionality is enabled using WD-EN pin or SET[1:0] pin combination…
Part Number: TPS35-Q1 Hello,
Which part numbers are available and can be ordered? According datasheet there are only two part numbers released:
TPS35AA38AGADDFRQ1
TPS35CA43DACDDFRQ1
If we select a certain type can it be assured that the device will…
Part Number: TPS35-Q1 Hi team,
My customer wants to use TPS35CA38GACDDFRQ1, but I cannot see this part in datasheet. I guess this part is not RTM now, so I wonder the timeline.
Another question:
If you will not produce this part in the future, can you…
Part Number: TPS35-Q1 Hi team:
my customer have a use case want to use TPS35-Q1 version, base on the PPS35AA38AGADDFRQ1 available part# in the spec.
I post the my understanding & questions as attached.
can you help to review and get feedback to me…
Part Number: TPS35-Q1 Hi team,
What is the drive strength of RESET pin? From below, does it imply it has driving strength at least 2mA? If yes, can I calculate the minimum pull-up resistance = (VDD - 0.3V)/2mA?
Part Number: TPS35-Q1 Other Parts Discussed in Thread: TPS35 Hi Team,
I'm searching one watch dog timer that can monitor the I2C SCLK ok or not. But we need adjustable time_out and delay time.
And VDD monitor feature is optional. May you help check…
Part Number: TPS3431 Other Parts Discussed in Thread: TPS35-Q1 , TPS3435 , TPS3851 , Hi team,
Could you confirm whether the WDI pin can support 16MHz?
Are there any devices whose WDI pin can support 16MHz? Do you think devices below can support it?
TPS35…
Add-On:
The TPS35-Q1 has separate /RESET and /WDO outputs and a orderable(?) option with latched outputs. The behavior after entering the latched state is described on page 24: /RESET remains high, /WDO remains low. (The described AND for both signals…