Part Number: TPS3852-Q1 Hello,
I have the following schematics of the part:
The power supply is 3.3V and I am testing with a regulated power supply the voltage monitoring of the part. When I decrease from 3.3V to 2.5V the power supply, theoretically…
Part Number: TPS3852-Q1 Tool/software: Hi,
I would like to know the values of input low current (IIL), input high current (IIH), output low current (IOL), and output high current (IOH) for TPS3852-Q1.
Thanks & regards
Priyanka S P
Part Number: TPS3852-Q1 Other Parts Discussed in Thread: TPS36-Q1 , TPS3436-Q1 We have a requirement as highlighted below -
Here, the requirement is clear as separate time based & window watchdogs.
Timing is not the issue here, but the type of…
Part Number: TPS3852-Q1 Hi Team,
My customer find when they pull down the SET1 Pin to GND, the WDO/ still has the output, which is not matched with the following waveform.
Only when they re-start the device (power off then power on), the WDO/ can…
Part Number: TPS3852-Q1
hi team,
could you help support this problem.
VDD to 3.3V, CWD to ground via 100pF capacitance, SET1=1 If the VDD voltage remains at 3.3V, What should the WDO output waveform state when the WDI input waveform is in the tPULSE…
Part Number: TPS3852-Q1 Other Parts Discussed in Thread: TPS3852 , Hello,
I received the TPS3852G33DRBR today and tested it on our circuit, but it didn’t work as expected.
The WDO works as expected if WDI stays high. I see the pulldowns every ~84seconds…
Part Number: TPS3852-Q1 Other Parts Discussed in Thread: TPS3890-Q1 , TPS3852 , TPS3890 Hi Expert,
Our customer uses TPS3852-q1 in their project. But they don't use TPS3890-q1, which is suggested in datasheet as below. The SET1 pin is directly tied…
Part Number: TPS3852-Q1 In our application, WDI is 0.5Hz (1s tick - 1s on & 1s off), so to use TPS3852-Q1, the selected cap value is 33nF (based on below formula).
Need TI's confirmation to ensure this configuration (33nF) will work for 0.5Hz WDI. …
Part Number: TPS3852-Q1 Other Parts Discussed in Thread: TPS3852 , TPS3703 , TPS3702 , LM4041-N , LM2903-N I have a question about the WDI minimum pulse duration spec.
Is it referring to 't' or 'd' in the picture below:
