Part Number: TPS389006Q1EVM Other Parts Discussed in Thread: TPS388008 , TPS389006 Tool/software: Hi everyone,
Recently, we did a monitoring test with a TPS388008001 and the evaluation board TPS389006Q1EVM on the software device TI Fusion Power Designer…
Part Number: TPS389006Q1EVM Other Parts Discussed in Thread: USB-TO-GPIO2 , Tool/software: hi Team,
is there an advantage to customer using our USB-TO-GPIO2 with above mentioned board vs. using any other way to connect?
e.g. I2C mapping, integration…
Part Number: TPS389006Q1EVM Other Parts Discussed in Thread: USB2ANY Hello TI TEAM
After the software (Fusion Digital Power Designer 7.7.8) is installed, EVB is configured according to the instruction manual. After many attempts, the USB2any green light…
Part Number: TPS389006Q1EVM Other Parts Discussed in Thread: TPS389006-Q1 The chip can not be written through I2C port;
I want to set bank_sel register (0xf0) to 1, choosing bank 1; but stil 0(bank 0).
Hi Dinesh,
If you look at the datasheet the 10k pull-up requirement are mentioned for the open drain active low output (NIRQ and NRST).
For I2C, you can use 4.7k Ohm. In our evaluation module ( TPS389006Q1EVM ), the pulls up for SDA and SCL are 2…
Hi Ahnaf,
Thanks for your question!
Unfortunately there is no IBIS model for these devices. One possible alternative could be to order the device evaluation modules and conduct tests with hardware.
Here is an example EVM for TPS389006:
https:…
Hi Youngho,
The EVM is https://www.ti.com/tool/TPS389006Q1EVM The adapter is: https://www.ti.com/tool/USB-TO-GPIO2
If you would like to use the sequence feature in your design you would have to have to design in a blanking time where the TPS38900…
