SI,
Please see the attached presentation. It was originally prepared for the LM10010 which was later superceded by the LM10011 which has higher precision. Please also see the many E2E posts discussing the LM10011 and TPS56121 with C667x and C665x. …
Since this error is happen by chance or say system instable, I have re-work on the loop circuit value
but it not helping, the above waveform still happen by chance. (e.g. 2~3 times out of 10 enabling)
Here is my loop calculation table
7206.TPS40428…
Part Number: TPS40428 Hi Sir,
I am working with TPS40428 on my system, it is working and output 1V to FPGA constantly.
But at the same time the PMIC have a 520mV Vripple output and affecting other voltage rails, may causing failure on DRAM calibration…
Part Number: TPS40428 Hi Ti team,
I have build a board with TPS40428 and 2x CSD95378B for evaluation, using 12V input to provide 1V output, design reference from PMP9444
but now my system have 2 issues
1/ OVF are easily triggered when enable TPS40428…
Denny Huang
The schematic looks better now.
Looking at the compensation spreadsheet, I had to change the part number to TPS40077, and after doing do, I noticed that the phase margin at the L-C resonance is very low. Looking into why, I can see…
Amir Eshraghi
I took a look at the compensation. It is certainly conservative for a 1.2MHz switcher, but I don't see any issue. I have attached the Excel spreadsheet with the loop analysis. TPS40KType III Loop Stability kVenable_TPS40305.xls
So…
Noman Paracha
The 2x 15uF tantalum capacitors are not strictly needed by the TPS546C23, but may be helpful in decoupling dynamic loading on VIN from other supplies, or distribution drops on your 12V supply rail, it depends on your system requirements…
Other Parts Discussed in Thread: TPS56121 art Number: TPS56121
Hi team,
Could you help me to find an appropriate value for inductor and loop compensation RC?
I'm trying to design TPS56121 in the operating condition of 10.8Vin, 5.5Vout, 2.8Aout…
