Part Number: TPS40170-Q1 Other Parts Discussed in Thread: TIDA-020033 , LM5123-Q1 , , LM5146-Q1 Tool/software: Hi team,
My customer would like to achieve class H solution based on the reference design of TIDA-020033, and he considers TPS40170-Q1 for…
Part Number: TPS40170-Q1 Other Parts Discussed in Thread: TPS40170 , LM5145 Tool/software: We are implementing an OVP/UVP circuit on the output of this part and pulling the Hside FET gate low during a fault condition. Is there any harm with loading HDRV…
Part Number: TPS40170 Hi All,
Please tell me about the difference between TPS40170 and TPS40170-Q1. I understand the difference in in-vehicle products, but are there any functional differences? TPS40170-Q1 mentions Adjustable current limit, but there…
Part Number: TPS40170 Other Parts Discussed in Thread: LM5145 , LM5146 What is the minimum tON(min) regardless of Vin and fsw? We need this value to calculate the maximum fsw to use under a certain operating Vin and Vout.
The tON(min) spec in the datasheet…
Part Number: TPS40170-Q1 Hi Experter,
We saw a tiny induced voltage at low side gate ,while high side gate turn on as below waveform.
it too close to MOSFET Vth minimum.
Is there a possibility cause High/low side short through?
could you have…
Part Number: TPS40170-Q1 Hi TI Team,
The EMC test of CE voltage has been failed on my customer's board using TPS40170-Q1. Are there any points to resolve and improve this issue? Please check an attached file and let me know that.
TPS40170QRGYRQ1_Failed…
Part Number: TPS40170-Q1 Hi Team,
My customer has the following question:
We have a question about the information in the data sheet. It is about the maximum temperature that is specified for the TPS40170-Q1 as Ambient Temperature TA with +125°C…
Part Number: TPS40170-Q1 Other Parts Discussed in Thread: LM5141-Q1 , hi
If same Load condition: LM5141-Q1 & TPS40170-Q1, which one performance is better?
Part Number: TPS40170-Q1 Other Parts Discussed in Thread: LM25116 , TPS40170 Hi ,
I Have used TPS40170QRGYRQ1 in one my new prototype design where the i/p is between 5V to 30V and o/p required is 3.3V @15A (max), 8 A(typical), 4A (min).
I have referred…
Part Number: TPS40170-Q1 Hi Sir,
In datasheet, the maximum rating of EN pin is 8.8V but it is "Output voltage".
EN pin should be input, so is this typo?
The maximum rating of EN pin 8.8V is still valid?
Thank you.
