Part Number: TPS40322EVM-074 Is it possible to modify the output voltage of the TPS40322EVM-074 to give 2V@18A. The default setup is 1.2V@30A.
I tried using WEBENCH POWER DESIGNER but the tool always produces a single phase design.
Bill
Part Number: TPS40322 Hi,
To verify a design, I want to simulate a schematic with this part. Unfortunately there is only encrypted PSPICE model. The TINA takes ages to simulate. Can you guys send me an unencrypted PSPICE model for TPS40322? I am happy…
Part Number: TPS40322 Hi TI Expert,
A simple question about TPS40322 (Voltage Mode Control) PWM chip:
How does TPS40322 behave when the Load Current (I_dc) decreases lower than 50% of the designed Inductor Ripple Current (ΔI, or I_ripple) ? Does…
Part Number: TPS40322 Hi, I know if want to enable this part. I need to floating this pin. It's about 6V on this pin when IC turn on that measurement it.
Where does this 6V come from?
I don't see any description about this high level voltage in the…
Part Number: TPS40322 Other Parts Discussed in Thread: LM25119 Hello Team,
My customer is working with TPS40322 at voltages bigger than 5.6V (max. permitted in the datasheet). Since this is not applicable they wanted to know if we can suggest a single controller…
Part Number: TPS40322 Customer wants to control sequence through EN pin.
For TPS40322, we can pull EN to GND to disable IC, and float to enable, but we cannot pull EN to 3.3V to enable IC, right?
Part Number: TPS40322EVM-074 Other Parts Discussed in Thread: TPS40322 Hi E2E team,
My customer tested the TPS40322 EVM and found there has a negative voltage of about -250mV in the following test item.
1. OLP test, C1(yellow) : Vin, 12Vdc , C2(red): Vout…
Hi Ridge,
we are thinking of using TPS40140 for this application (even though it is an old part and no longer recommended by TI for new designs. Unfortunately the alternative suggested TPS40322 doesn't support the Vin range!). Does TPS40140 has any limitations…