Part Number: TPS4810-Q1
hello,there is a question about TPS4810/TPS4800.
We want connect the net "VBATT" to a Charger,and then connect "VOUT"to a battery.In order to prevent the "VOUT" current from flowing back to the "VBATT",we will adopt this back…
Part Number: TPS4810-Q1 Hi there, I am designing a BMS for 48V lithium batteries. The continuous current is to be 200A. Ff the back to back to back MOSFET bank is on the high side, I have to pull BAT+ and PACK+ to my PCB, in addtion to the BAT- and PACK…
Part Number: TPS4810-Q1 Hi Team,
I would like to use a TPS4810 to switch two power N-mos in a back to back configuration on a 48V power line.
I would like to power the TPS4810 VS pin with a 5V power supply and drive pin EN, INP1, INP2 also with this…
Part Number: TPS4810-Q1 Tool/software: Hello, We have the following design specifications. Input voltage range: 9-80V UVLO 18V OVLO 36V OC trip: 100A Reverse Voltage Protection - 50V Short Circuit Protection Fault or PG output It looks like the TPS4810…
Part Number: TPS4810-Q1 Other Parts Discussed in Thread: TPS4800-Q1 , , TPS4812-Q1 Tool/software: What are the main differences between TPS4800-Q1 and TPS4810-Q1? Also, do both support bidirectional current detection function
Part Number: TPS4810-Q1 Tool/software: Hi,
I have two questions about TPS4810-Q1, please kindly help confirm:
1) If I set low-side current sense configuration(CS_SEL is pulled to high) for TPS4810-Q1, can it support bidirectional current detection…
Part Number: TPS4810-Q1 Hi team,
I have two questions on CS_SEL pin. My customer is using it for high-side MOS driver and low-side current sense in battery pack.
Their current design binds CS_SEL and EN/UVLO together, which will cause CS_SEL pulled…
Part Number: TPS4810-Q1 Other Parts Discussed in Thread: STRIKE
Hi TIer
My customer use TPS48100 in their product.
They do the 8kV ESD test in product.
I found that the chip was not short-circuited after I had done the 8kV ESD experiment, but…
Part Number: TPS4810-Q1 Hi team,
The customer need to add resister between gate and source:
What is the maximum constant output current on G1 / G2 that will not affect device function?
BR,
Xinyu
Part Number: TPS4810-Q1 Hi TI Expert,
I am trying to implement a separate precharge path using a dedicated precharge resistor and precharge FET by utilizing the G2 output.
As described in the datasheet. I can control the G1PU and G2 outputs separately…
