Part Number: TPS4811-Q1 Tool/software: Hi Expert,
I would like to check if TPS4811-Q1-G Pin can be Discharge PATH?
The 2nd question is that please see below structure, can I use INP and INPG to control back to back MOS?
Thank you
Part Number: TPS4811-Q1 Tool/software: Hello support,
I am using a design which was intended for the TPS48111 driver. Because it was not available i have used the TPS 48110 and i have a strange issue.
On the same board i have 2 drivers one driver with…
Part Number: TPS4811-Q1 Other Parts Discussed in Thread: TPS48110Q1EVM , Tool/software: Hello,
My application:
60V input
2A OCP with 2.25A SCP (fast, ~uS reponse time, latching)
200hz PWM control, high side switched
I have purchased the tps48110Q1EVM…
Part Number: TPS4811-Q1 Tool/software: Hello,
We are working with the TPS4811 and the charging up the bootstrap capacitor is not quick enough. Are there other options beyond externally supporting this BST cap with an external supply attached on the positive…
Part Number: TPS4811-Q1 Tool/software: Hello,
We have a question on the TPS4811 CSA. Would the connection in the figure below (black between battery input and MOSFET) . We are trying to understand what would happen if we were to use the low side shunt (the…
The accuracy at 31mV should be better than at 10mV. In your case, may be solder resistance is adding up and tripping at lower current than expected.
Beyond 30mv, the accuracy remains same.
Part Number: TPS4811-Q1 Other Parts Discussed in Thread: LM5069 Tool/software: Dear Support,
I'm developing an high current power distribution box from 48V supply with multiple outputs. At the moment I'm designing the switch with a TPS48111Q1 with the…
Part Number: TPS4811-Q1 Other Parts Discussed in Thread: LM5149 , Tool/software: Dear All,
for a new project in develepment of a 28V 3,5A, 6,5A and 12,5A power supply with 2 lead acid batterie back-up, we have 2 indipendent output originally protected…
Part Number: TPS4811-Q1 Tool/software: Hi,
I am using TPS4811 for mosfet driving.
When i am applying the signal at INP, Not getting signal at PU or PD.
I had done simulation on PSPICE TI, Its working fine there but not working on by board
Note :- I…