Part Number: TPS4811-Q1 Hi team,
If customer use TPS4811-Q1 in below sch configuration (replace TPS1211 to TPS4811) and reverse connect 48V Vbat, will VSRC=-48V+ VF (MOSFET Q1 body diode)=-47V?
If that's the case, does it mean this socket is not very…
Part Number: TPS4811-Q1 Hi Team,
I'm designing n electronic board to drive a DC brushed motor (permanent magnets).
The voltage range is 9-32V.
The motor controlled by a H-bridge so as to rotate in both directions.
The motor speed is controlled…
Part Number: TPS4811-Q1 What is the maximum sink current I(PD) of the TPS4811-Q1 when V(VS) = 25V to 55V and EN/UVLO is 0V and what is RPD in this case?
I need to be sure that the VGS of the external MOSFET is low when the TPS4811-Q1 is in low quiescent…
Part Number: TPS4811-Q1 Other Parts Discussed in Thread: LM74930 Tool/software: Hi!
Basically I need switch for inductive load for 48V system
But in our system we have spikes up to 110V
I want to move current sense part after MOSFET and protect…
Part Number: TPS4811-Q1 Tool/software: Hello everyone here, this is my first time in a E2E forum, initially i was seeking for any solution for random FET failures with TPS48111 driver and 2 days ago I found this thread which is also mostly describes my…
Part Number: TPS4811-Q1 Tool/software: We've seen transients across the Vs and Gnd pins of the TPS4811-Q1 that can damage the part. We'd like to add protection. We are thinking of adding a TVS and resistors. The datasheet suggests an 100 ohm in series…
Part Number: TPS4811-Q1 Tool/software: Hello,
so i was reading the datasheet for this component and on page 18. there is a figure 8-6 with this commentary
"Use a damping resistor R2 (~ 10 Ω) in series with C1. Equation 3 can be used to compute required…
Part Number: TPS4811-Q1 Tool/software: Dear Support,
I need to use the TPS48111 in a switching application at 48V. I plan to use the VAUX feature with the diode on the BST pin. The datasheet states that you can use a VAUX up to 15V. In a 48V configuration…
Part Number: TPS4811-Q1 Tool/software: Hello experts,
I want to know until how many amperes we can set using RIWRN resistor.
In document of TPS4811-Q1, the resistor of 52.88kohm is calculating to set 15A.
I want to set the overcurrent protection…
