Part Number: TPS48110Q1EVM Tool/software: Hi, I downloaded this model form your website, imported it using Ppsice Model editor. I inculded the lib in simulation settings. I am still getting this error that this device can noz be simulated. do I need an…
Part Number: TPS48110Q1EVM Tool/software: Hi there,
I have used your inrush calculator for the fet I have chosen for my design, and I have a couple of questions.
In Step 2, is the SOA graph that the calculator produces purely for interest, or should…
Part Number: TPS48110Q1EVM Tool/software: Hey there,
I am trying to run a simulation with the TPS4811 0 -Q1_TRANS model in pSpice (for TI). It keeps having errors of 'Pin G' and 'Pin INP_G' found in template but not on my part. The symbol has the correct…
Part Number: TPS48110Q1EVM Tool/software: Hello,
the minimal V(VS) of the TPS48110Q1 is specified according to the data sheet as 3.5V. But the evaluation modules states "24-V to 60-V (typical) operation".
Is this limitation of the minimal supply voltage…
Part Number: TPS48110Q1EVM Other Parts Discussed in Thread: TPS4811-Q1 Dear support team,
We use the TPS48110-Q1 module in our project. We require a short-term storage temperature of up to -55°C.
According to the data sheet, the storage temperature…
Part Number: TPS48110Q1EVM Hi, I'm having a quite strange problem with an own design using TPS48110 IC. I have the following conditions:
-> VBAT applied, between 14 and 62V.
-> 100 Ohm load connected. We have tried with a 1 and 2 A load too.
…
Part Number: TPS48110Q1EVM Hello.
I would like a schematic and artwork (PCB) file of the TPS48110Q1EVM.
I would like to study that board.
If possible, please send it in the comments or one of the emails below.
1. jaeyup7971@naver.com
2. jungjy…
Part Number: TPS48110Q1EVM Hi,
I am using the TPS48110Q1EVM board with 24.6Vin/12A capable power supply at the input and an electronic load at the output.
When the electronic load is set to just 0.1A load settings and is enabled it is very difficult…
Part Number: TPS48110Q1EVM Hello,
At first, it was found that the mosfet did not output, but later it was found that there was no signal on the PU/PD pin of TPS48110. Continuing the inspection, it was found that the capacitor voltage from BST to SRC…
