Part Number: TPS51275C Hi Teams,
We are currently encountering a short between PIN8 (SW2) and PIN9 (VBST2). On a normal board, the impedance is 1.8M ohm. What could be the cause of this damage? How can this failure be reproduced through experimental…
Part Number: TPS51275C Hi Team,
As shown in the figure below, this is the output OVP waveform we tested. Please help check whether the behavior of the Enable signal and the output voltage is normal, thanks.
Ch1: Vout, Ch2: PG, Ch3: Enable, Ch4: V…
Part Number: TPS51275C Other Parts Discussed in Thread: TPS51275 Tool/software: I found the listed device via TPS51285, which ahs a listed operating temperature range of-40 to 85C. This range is reflected in the datasheet. My issue is that the TPS51275…
Part Number: TPS51275C Hi team,
I always assume the output current maximum is limited by the external FET, but TI.com show the Iout max is 20A for TPS51275C, want to know why?
can we use it for 30A?
BTW, why do the output fixed at 3.3 and…
Part Number: TPS51275C Customer wants to use this part in their PC application, and not sure whether there is limitation for the output current. Can it push to 20A for each output?
Part Number: TPS51275B Other Parts Discussed in Thread: TPS51275C Tool/software: Hi,
We have test TPS51275B Standby current about Iin = 23mA, it higher than other competior Richtek RT6575.
Is any other way to reduce standby current? Thanks!
Part Number: TPS51275B-1 Other Parts Discussed in Thread: TPS51275B , TPS51275C ,
Asking for the TPS51275B-1RUKR design suggestion
Hi Sir,
My customer would like design TPS51275B-1RUKR to generate 3.3V. In order to improve the light load efficiency…
