Part Number: TPS53319 Hi,
At the datasheet page of 19, it was mentioned - Enable voltage should not higher then VREG for 0.8 V.
Could you explain what it means? Under the absolute ratings, the EN pin could tolerate 7.0V max.
Thanks.
Best rgds…
Dear Kit,
We have to stick on TPS53319. We don't have choices for that. I contacted local FAE to get the Excel file and I received it well.Thanks for notification. I have already applied RCC network referring to Webench RCC network. That is similar…
Part Number: TPS53319 Hi,
I want to ask about Itrip specification for TPS53319.
In the datasheet in mention for typical value at 25℃
Please provide the minimum and maximum value for Itrip.
Thanks.
Part Number: TPS53319 Other Parts Discussed in Thread: TPS548A20 , Dear Specialists, Customers need FMEA information to adopt new parts. Please tell me the FMEA information of TPS53319 and TPS548A20. It helps in design-in.
Best regards, Yusuke
Part Number: TPS53319 Tool/software: WEBENCH® Design Tools Hi all,
I used WEBENCH tools in TPS53319 , but result is "There are no waveforms for this simulation".
My design condition : Vin=12V / Vo=5V / Io=14A / L=1.5uH, DCR4.1mR / Output cap 560uF…
Part Number: TPS53319 Hi Team,
My customer wants to use TPS53319, and VCC=5V.
I noticed there is an integrated LDO, so I want to know when VCC=5V, and there is no other load connected to Vreg except RF pin via resistor, what is the output LDO voltage…
Part Number: TPS53319
Hi, Customer is trying to control sequence by controlling EN with CPLD
Customers connect the EN pins of multiple devices to one signal source. In the background, customers are looking into pull-up resistor constraints. １．Does…
Part Number: TPS53319 Hi,
I had integrated on my design some TPS53319 configured based on WEBENCH designs.
My system is actually characterized by an high HF noise due to ringing oscillations.
I had measured these HF spikes on both input and output…
Part Number: TPS53319 The Schematic Diagram
When its output is below 3A, everything goes well. But when the load resistor is decreased, and it supposed to output more current. Its output turns to a sawtooth wave.
CH1 is the output voltage, CH2…
Part Number: TPS53319 Hi, In the customer board, there was a problem that overcurrent protection occurred at a current lower than the set OCP.
Customer uses the following formula. When estimating the OCP minimum, can you tell me each number to substitute…
