Part Number: TPS53624
Hi expert,
Customer used TPS53624 and when they are doing fast POR(simulate electricity blackout) test, they found the output would latch when they turn off and on with 40ms~100ms turn off time (they did every 20ms per step)…
Part Number: TPS53624 Other Parts Discussed in Thread: TPS51727 , Hi TI expert,
May I please have the DCR Sensing Excel Solver Spreadsheet for TPS53624 as well? Though I suppose it might the same as the one for TPS51727.
Many thanks,
Roy
Part Number: TPS53624 Our project needs to work stably at minus 40 ℃. Tps53624 manual has two temperature parameters, - 10 ℃ ~ + 105 ℃, and - 40 ℃ ~ + 125 ℃. We have designed the circuit according to the manual and tested it. It is found that the test…
Part Number: TPS53624 Other Parts Discussed in Thread: TPS51727 , TPS53626 , TPS53647 , TPS53627 Dear team,
My customer are curious about the working temperature of TPS53624 when using it.
From datasheet, Ta seems between -10 ~ 105 degree C, but Tj…
Part Number: TPS53624 TI experts,
Just one simple question this time:
Can TPS53624 support non-droop implementation (i.e. load-line = 0)? If yes, how to implement it? If no, what is the minimum load-line supported by this part?
Thanks and regards…
Part Number: TPS53624 Hello,
I am considering using the TPS53624 to provide the core voltage supply for an FPGA reference design (0.95V, 50A). In step 5 of the design procedure, the datasheet mentions an Exel solver for the DCR sensing circuit. Can…
Other Parts Discussed in Thread: TPS53624 Hola,
As subject, below is our schematic and the current design is TPS53624 from 12V to 1V with single phase, transfers output voltage is 1.00625V(without ROV).
Below figure is +1V normal waveform and we can…
Other Parts Discussed in Thread: TPS53624 Hello,
For the TPS53624 Enable pin - it is stated in the datasheet that it is a 3.3V logic input. Does it have a hysteresis and if so any specific levels?
This is for an application where the EN signal has…
Other Parts Discussed in Thread: TPS53624 Hi Sir,
I set the PCNT of tps53624 as logic low (0V), but I found, when Iout=20A, the controller still works in single phase. In which load condition the controller works in dual phases, or is my configuration…
