Part Number: TPS53915 Other Parts Discussed in Thread: TPS40400 Tool/software: Hi,
We are trying to find driver support for TPS53915 but not able to get so. Just wanted to know if TI has Linux driver support for this chip.
Regards
Narendra Sing…
Part Number: TPS53915 Other Parts Discussed in Thread: TPS549B22 , TPS548B22 Hi Team,
I am looking for a device which can support the following requirement:
1. Vin=2.5-5.5V
2. Vout=0.5V-1.2V, typical 0.6V
3. Iout_max=12A
I could see that TPS53915…
Part Number: TPS53915 Hi,
just realized the maximum voltage on the EN pin is stated to 7.7V in datasheet. We have been using using 10kOhm PU to 12V for multiple units for a few months now and just recently ordered new PBAs with the same design.
…
The title of your post subject is "TPS53915: find another DC/DC solution to generate 0.95V" but you are asking for a p2p to FP6385.
The TPS53915 is 4.5x3.5 12A device with PMBUS and the FP6385 sot-23 3.5A device.
I am going to change the subject line…
Part Number: TPS53915 Other Parts Discussed in Thread: TPS53515 Hi,
Can off-line programming TPS53915 to change FW setting before use.
For example, I would like to change TPS53915 frequency setting from 400kHz to 850kHz.
Thanks
Tony
Part Number: TPS53915 Other Parts Discussed in Thread: TPS53513 , TPS53515 , TPS549A20 , TPS548A20 Hi,
Could TPS53915 as TPS53513 alternate source?
What's the circuit design different?
Part Number: TPS53915 Hi experts,
The PCN# 20170804000C states a change in the material of the lead finish - NiPdAU (E4) and Matte Sn (E3)
2 questions:
a. Can customer used part# of both finishes inter-changably w/o making production line changes…
Part Number: TPS53915 Other Parts Discussed in Thread: TPS549A20 I was also looking another Device from TI "TPS53915RVER" as an alternate part of "TPS549A20RVER".
As i know TPS53915RVER is a 12A device, which is good enought for the design load.
One…
Part Number: TPS53915 Hi
We are using TPS53915 in new designs for
12V to 3.3V, 2.5A
and
another config for 12V to 5V, 7A
In both modules o/p is not coming and not switching. The design cross checked with Webench and seems to be fine.
Observations…
