Part Number: TPS54232 Other Parts Discussed in Thread: TPS62816-Q1 Hi ,
We are using DC-DC converters having part numbers TPS54232D/DR and TPS62816-Q1 in our design. Please provide us following details for the components:-
1) What is the Lead time…
Part Number: TPS54232 Dear Sir,
I am considering a circuit that uses a TPS54232 to generate 5V.
What is the reason for the "Choose R5 to be approximately 10 kΩ." listed in the data sheet (SLVS876D p15) ?
Since I want to choose from Standard Resistor…
Part Number: TPS54232 Dear Sir,
One of our customer using TI's TPS54232 for main power. Input 12V, output 3.8V @ 2A. The following picture shows our customer design.
I have used WEBENCH tool to do design. There are shows some different setting. Could…
Part Number: TPS54232 Other Parts Discussed in Thread: TPS54531 Hi Team,
Do you have any devices Pin to Pin with TPS54232D, the output current up to 4A.
I find we have TPS54531 have Io 5A.
Any recommendations?
Thank you.
Best Regards,
Xing…
Part Number: TPS54232 Hi,
We got a question from customer about TPS54232.
Could you help us?
[Question]
Regarding the behavior of TPS54232 when the adjacent pin is open-shorted,
If there are some results of evaluation on the following cases…
Part Number: TPS54232 I have problem with the stress test of TPS54232D. Vin is 15V, Vout is 12V. For stress test when I connect a light load 10Ohms at the output, current consumption is 600mA and output voltage drops to 8V. But in datasheet it is written…
Part Number: TPS54232
Hi,
We want to know that is it correct that input current consumption be 30mA more when we change D25 from ES1G_YJ to FR1G?
If yes, why?
If not, what may cause this problem?
Thank you.
FR1G.pdf ES1G_YJ(1).pdf
Best…
Part Number: TPS54232 Hi,
Input Voltage: upto 24VDC
Output voltage: 7V and then it goes to 5V LDO to power 5V MCU.
I am trying to understand how UVLO works and hysteresis. In the datasheet, it is recommended to add hysteresis using Ren1 and Ren2…
Part Number: TPS54232 Other Parts Discussed in Thread: TPS563208 Hi Non-Isolated DC/DC team
We want to disable pulse-skipping ECO-MODE
Because We suppose to have many ripple at output(PH) as a below when enter lights loads under 150mA. I confirmed…
Hi,
You can use WeBench to do the simulation.
https://webench.ti.com/power-designer/switching-regulator/customize/137?AppType=None&Flavor=NA&O1I=2&O1V=5.0&Topology=BUCK&VinMax=20&VinMin=20&VoltageOption=NA&base_pn=TPS54232&flavor=NA&lang_chosen=en_US&op_TA…
