Part Number: TPS5430-Q1 Other Parts Discussed in Thread: TPS5450 , TPS5430 Hello,
How long will the TPS5430-Q1 be produced? Is it planned to be discontinued? I am not sure about using the TPS5430 series as the TPS5450 series will be discontinued.
Part Number: TPS5430-Q1 Other Parts Discussed in Thread: TPS5430 Hello,
Is it possible to use the automotive chip TPS5430-Q1 in the same way annotated in the application notes of TPS5430 describe to invert the voltage produced? I don’t see why this…
Part Number: TPS5430-Q1 Hi Sir,
My customer asked there could not find the AEC-Q100 word in the D/S of the TPS5430QDDARQ1. May I know whether this device passes the AEC-Q100 testing? Have new D/S or other document will show this device pass the AEC…
Part Number: TPS5430-Q1 Hi All ,
i found the FTA diagram for TPS5430-Q1 stating the undervoltage fault.
- Can you please let me know if the FTA diagram for other fault conditions like over voltage, over current etc.. are separate ?
- Can you please…
Part Number: TPS65131-Q1 Other Parts Discussed in Thread: THVD4421 , TMUX7234 , TPS65131 , TPS5430 , We are currently designing a dual-protocol (RS-232 / RS-485) transceiver circuit (similar to the THVD4421). According to the customer’s pin definition…
Hello John,
Thank you for your reply.
After I separated the inverting converter from the rest of my circuit and loads, I connected an electronic load and did some tests. I used the constant current setting on the load (BK Precision 8500). The regulator…
Other Parts Discussed in Thread: TPS5450 , TPS5430-Q1 Hello,
I successfully used TPS5450 -Q1 and TPS5430-Q1 circuits to provide +5V from a 14V battery voltage.
However, I need to understand and deepen the behavior of the chopper in a mode of failure…
Part Number: TPS5430 Hi, team.
I have a question about TPS5430.
So, please tell me about this.
Q1：In Figure 8.2.3 in the data sheet there is a phase compensation circuit, is this circuit absolutely necessary?
(8.2.3 Circuit using Ceramic Output…
Part Number: TPS65131-Q1 Other Parts Discussed in Thread: TPS65131 , TPS5430 Hi All,
I am trying with Webench
how can i simulate the design with this part TPS65131RGETG4 to check for voltages across the different components when I set the output…
Hola John,
Thank you for your reply and sorry my fault it's caused by TPS79801-Q1 not TPS5430！
Yes, I have measured the current at output side from TPS79801-Q1, when device is at normal temperature and the output current is about 20mA,
but when…
