Part Number: TPS54316-EP Hi,
I want to know the details about the rise and falling edge deglitch circuit which is 2.5us. If the VIN didn't exceeds the UVLO start threshold voltage of 2.95V within 2.5us does the ic will be in a shutdown mode or the rising…
Part Number: TPS54316
1.I want to confirm that does the input voltage (5V) from the power source should exceed 2.95V (UVLO START THRESHOLD VOLTAGE) within or equal to 2.5us(rise time) to turn on the device or else will it go to shutdown mode and if…
Part Number: TPS54316 Hello,
I am considering using the TPS54316PWPG4 DCDC converter.
When I attempted to test the part, a waveform like the following was generated.
Waveform
Circuit diagram
Parts Used: inductor ：RLB0913-100K（10µH）×1 capacitor…
Part Number: TPS54316 Other Parts Discussed in Thread: TPS62810M I am designing a 3.3V regulator solution with the TPS54316MPWPREP. Our FPGA will control the enable signal on the regulator so that it becomes enabled only when the ambient temperature read…
Part Number: TPS54316 Hi Team,
As TPS54316 do not need external FB resistor, so we don`t know how to simulate loop stablity in TINA, do you have TPS54316 loop stablity simulation TINA example? Or some guide line?
Thanks very much.
Regards ,Sunn…
Part Number: TPS54316-EP Other Parts Discussed in Thread: TPS54312 , TPS54314 Hello TI Team,
We are planning to use TPS54316MPWPREP in one of the products which are used to convert 5V to 3.3V power supply,
We required 3.3V-3A maximum output and temperature…
Part Number: TPS54316 Other Parts Discussed in Thread: TPS54311 Hello, I'm having issues understanding the step regarding choosing the output capacitance. I've been following the guide "Designing With the TPS54311 Through TPS54316 Synchronous Buck Regulators…
Part Number: TPS54316 We design 3.3V/3A output power using TPS54316, the input voltage is 5V. There are two questions on the open drain Pin4 - PWRGD:
1) We normally design PWRGD as a float pin, not connect and no impact to other circuit. Is it correct…
