Part Number: TPS54325-Q1 Hi,
My design parameters are as follows:
Vin=5V, Vo=1.375V, Io=2A
when start up with load(the load is a CPU), no output voltage.
but when I cut off load, no load start up , output voltage have normal volt.
check Vin…
Other Parts Discussed in Thread: TPS54325-Q1 , TPS54325 I have a customer who is asking a question on the ramp up of the VREG5 circuit in the TPS54325-Q1.
The block diagram seems to indicate that VREG is supplied directly from VCC. But is the ramp up…
Hello Denny,
Apart from -Q1 qualification, the functionally of these two devices are identical.
Please refer to the image below. The Features on the right represent the TPS54325TPWPRQ1 device.
For TPS54325TPWPRQ1 datasheet reference: https://www…
Part Number: TPS54325 Dear support member,
The customer is mass producing the TPS54325.
I have a question and Urgent. The IC burned due to a short between the VIN（13pin） and VBST（12pin) pins.
（Question) Q1 Please tell me the mechanism by which the…
Part Number: TPS54325
Hi, team.
I have previously contacted the following inquiries.
e2e.ti.com/.../648546
I understand the features of D-CAP2 to a certain extent, but please let me know about question.
Could you help me?
＜Question＞
My customer…
Other Parts Discussed in Thread: TPS54325 Hi, My customer ask me as follows questions. Can you please give me advice?
(Q1)Now we separate the signal line GND and power line GND. If they connect the same GND, please let me know the potential problems…
Part Number: TPS54325 Hi team
this is my customer SCH could you help me to review it ?
because I will LOA next week
can you reply this week?
there are
one TPS54325 in page1
total 1
in attached files
BRs
brian
7532…
Hello Tsukui-san,
With FPGA's their actual power needs vary depending on the clock speed and other variables.
Therefore many times TI does not have a design for a specific FPGA.
One good way to build a design is to use Webench FPGA Architect.
…
