Part Number: TPS544C26 Other Parts Discussed in Thread: TPS544E27 Tool/software: Hi expert,
Customer used TPS544C26 and have to use I2C but face an issue that the REG_LOCK would always NACK and cause passcode can't succeed.
Would you please advise…
Part Number: TPS544C26 Other Parts Discussed in Thread: TPS544C25 , , TPS546C25 Tool/software: I would like to compare the transient response of the TPS544C25 , TPS544C26 and TPS546C25. But I couldn't find any relevant items in the data sheets. How should…
Part Number: TPS544C26 Hi team,
I am using TPS544C26 IC, one thing that I observed is when I am using RAddr resistor as 0ohms, and after checking in Fusion software I2C GUI scan device option, I am getting the device at 7Fh address whereas for 0ohms…
Part Number: TPS544C26 Tool/software: Hi expert,
Customer used TPS544C26 and try to change Vboot by i2c but failed. They have tried set on/off config to 001b I2C operation command and/or 011b EN pin and Operation command but all failed.
Would you please…
Part Number: TPS544C26
Hi Team,
I am facing some issues while programming TPS544C26 IC using I2C GUI in Fusion Software.
My desired Vout is 1.8V, Protocol ID is 10mV VR13.
1. a. When I am setting VOUT_CTRL as I2C only, Protocol ID as VR13, 10mV and…
Part Number: TPS544C26 Dear Sir：
I am a third-party programmer manufacturer and currently developing TPS544C26 programming software. I am used Fusion-Digital-Power-Designer-7.10.1 and cannot connect to TPS544C26. It seems that this Part number is not supported…
