Part Number: TPS5450 Tool/software: Hi Team,
I have used TPS5450DDAR for my 24-12v regulator and a oring controller IC to siwtch from Main power to Battery Power if main power goes off. Kindly validate the desgin and share your inputs.
Regards
Srinivas…
Part Number: TPS5450 Tool/software: IC "No output "the input DC is powered on.
The pad is 24V to 12V.
When the input is powered on at 24V, the output voltage cannot rise to 12V normally, and the current does not reach the Current Limit. Why does…
Part Number: TPS5450-EP Other Parts Discussed in Thread: TPS5450 Tool/software: Dear Team
The above mentioned part is not available in WeBench Instead Automotive is available.
I am using this extended part in my design, Will there be any differences…
Part Number: TPS5450 Tool/software: Hi,
Good day.
I would like to seek your advice on TPS5450DDAR schematic.
Currently we plan to use our P5V ENA pin with input from P3V3 output.
The purpose is due to some power sequence requirements.
Can…
Part Number: TPS5450 Other Parts Discussed in Thread: LMR51450 Tool/software: TPS5450DDA:
Need to check the part status of above-mentioned buck IC. Moreover, share the YTEOL details of the part.
With regards,
Preethi Sukumaran
Part Number: TPS5450 Hi TIer
Due to the discontinued on TPS5450.
Do we have the pin2pin device which can use in mass production?
Customers need some pin2pin products to help normal production of mass production devices, and they will be revised…
Part Number: TPS5450 Tool/software: Hello Team,
I have the below circuit for my application requirement. I tried using power webench and extracted the component values. The input conditions are 9-16V and the output requirement is 6.2V at 250mA least…
Part Number: TPS5450 Other Parts Discussed in Thread: LMR51430 Hi team,
When I tested TPS5450 with a long, thin cable, firstly in the unloaded condition, and then I shorted the cable (about 7~8 meters long, so in the waveform below, the output voltage…
Part Number: TPS5450-EP Other Parts Discussed in Thread: TPS5450 card.pdf
In the respective circuit a 3.8V is generated from +10V input. My queries are related to the noise reduction
1. In the input rail an inductor ,capacitor combination is used…
Part Number: TPS5450 Tool/software: hi expert
1.Design and application conditions: U1 input voltage 29.2V±0.5V, U1 output voltage 5.4V, output current 3.5A max
2.The schematic diagram of the two schemes is as follows: Scheme 1:
Note: C52/C104…
