Part Number: TPS54538 Other Parts Discussed in Thread: TPS65295 Hello,
I am using TPS54538 for a design and trying to simulate it using Xpedition AMS. Is there an unencrypted SPICE model for this part that I can use?
I am also using TPS65295 for the…
Part Number: TPS54538 Other Parts Discussed in Thread: PSPICE-FOR-TI the PSPICE simulation for TPS54538 (SLUM922.ZIP). Does not run with the following error messages:
ERROR(ORPSIM-15461): Incorrect number of interface nodes for X_U1.X_U7_U724. ERROR…
Part Number: TPS54538 Hi experts, I bought TPS54538 DC-DC converter and change the feedvack resistor to make it for 12V output application. We having issue when we put the load at output for 4A, it failed to boot up. This device should provide maximum…
Part Number: TPS54538 Tool/software: Question: In the TPS54538 datasheet (SLUSF22, November 2024), the Absolute Maximum Ratings (Section 5.1) specify that the RT/SYNC pin must remain within –0.3V to 6V. However, Section 6.3.5 (Switching Frequency Selection…
Part Number: TPS54538 Other Parts Discussed in Thread: TPS543521 Hi team,
What is the difference between TPS54538 and TPS543521? It seems the specs are totally same..
Best regards,
Shunsuke Yamamoto
Part Number: TPS54538 Tool/software: Hello,
I'm using this regulator to power a Raspberry Pi. I have a power board that the Pi plugs into and the circuit is on there. I essentially copied the example circuit provided for 5V 5A and am running the regulator…
Part Number: TPS54538 Tool/software: Dear TI Support Team,
We are facing an issue with the TPS54538RQFR in our design.
Input Voltage: 24V / 3A
Configured Output: 5V
Circuit: Followed reference design from the datasheet for 5V output…
Part Number: TPS54538 Other Parts Discussed in Thread: LMS3655 Hello E2E Experts,
I need a suggestion about the DC/DC converter with ripple parameter shown below. 24V->5.8V 3.5A Ripple = 0.1mV
Part Number: TPS54538 Tool/software: Dear Team,
My customer is simulating the TPS54538 by WEBENCH. Conditions: - VIN: 17V to 28V - Vout: 3.3V, 5.0V - Iout: 3A to 4A
In case of Vout=5.0V & Iout=4A, switching frequency can be set as 2.2MHz with L=1…
Part Number: TPS54538 Tool/software: Dear Team,
My customer want to simulate the TPS54538 by WEBENCH POWER DESIGNER, but "SIMULATE" of WEBENCH does not work. "Simulation not enabled for this design" appears.
When will the simulation of the TPS54538…
