Part Number: TPS54561 Hi TI,
I have designed a circuit to step down the input voltage of 48V to 24V with expecting an output current of 3.1A.Could you please verify the circuit to know any issues are there in the circuit. I also have faced an issue in…
Part Number: TPS54561 With the circuit of TPS54561 as below A problem occurred during use
[Problem]
- SW(No.9 pin) <-> gnd short
- If you remove the tps54561 during repair, The circuit of the input/output is normal.
input/Output specifications are…
Part Number: TPS54561 Other Parts Discussed in Thread: LM61480 Referencing:
https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1226147/lm61480-q1--5v-inverting-output-possible
Current PCB uses TPS54561 for +5V…
Part Number: TPS54561-Q1 Other Parts Discussed in Thread: LM25117 , , TPS54561 , TINA-TI Hi Team,
I’ve got a crash when running TPS54561-Q1 simulation with PSpice for TI. But try other chipsets (I try LM25117) was fine. Could the TPS54561-Q1 to be…
Part Number: TPS54561 I need clarification in part difference for TPS54561 and TPS54561-Q1.
From datasheet i could find following difference,
Parameter
TPS54561-Q1
TPS54561
ESD rating
Automotive AEC-Q100 AEC Q100-002 indicates HBM stressing is done…
Part Number: TPS54561-Q1 Other Parts Discussed in Thread: TPS54561 Hi E2E:
There is a production project with TPS54561-Q1. The device is used as a VIN=20V,VOUT=4.6V buck regulator.
We found out some of the device`s Output voltage ripple is over 0.5% of VOUT…
Part Number: TPS54561 Hi team:
My customer want to use TPS54561 at this parameter, wanna to check how make this 100% can work, and got confuse use some cal-tool for reference. Can you help to take a look?
tks!
Vin 24v
Voutput 23V 3A, 500khz.
1. it seems…
Part Number: TPS54561-Q1 Other Parts Discussed in Thread: TPS54160 , , TPS54561 Hi,
Can you please provide the tool regarding the compensation network.
See the below image for reference from MPN - TPS54160. I want the same tool for MPN - TPS54561-Q1
Regards…
Part Number: TPS54561
Dear Sirs,
If the Eco-mode is automatic switch or can be controlled?
If not, how to control it to avoid into the Eco-mode?
Thanks.