Part Number: TPS549D22 Hi TI,
I can't assert SMB_ALRT pin. The following is my test command.
Test command: # Check write protect. # 0x0: Enable writes to ALL commands i2cget -y 0 0x14 0x10 -> 0x00
# Read VOUT_MARGIN_HIGH i2cget -y 0 0x14 0x25 …
Part Number: TPS549D22
Hi Team,
Customer wants to change the voltage setting in the internal NVM.
It will be difficult for my customer to turn the output off while device is operating to use STORE_DEFAULT_ALL, as they would end up violating their power…
Part Number: TPS549D22 Other Parts Discussed in Thread: TPS549B22 , Question:
Can the PMBus pins on the TPS549B22 and TPS549D22 support a 1.8V I/O termination voltage for the pull-up resistors?
Answer:
The TPS549B22 and TPS549D22's PMBus pins are designed…
Part Number: TPS549D22 Hello,
My customer wants to use the TPS549D22 with the following conditions:
* PVIN=12V / VOUT=0.85V / Switching frequency : 650KHz
* Normal operation under the above conditions without PMBus control
Could you please review the…
Part Number: TPS549D22 Other Parts Discussed in Thread: TPS546D24A Hi Team,
My customer has PMBUS communication failure issue when using TPS549D22 (replace EM2260 ) with 1SG110HN2F43E2VG FPGA .
Question:
Does TPS549D22 have 8Bh register?
I find 8Bh in…
Part Number: TPS549D22 Hello,
Does the TPS549D22 have a SMbus register which indicates the effective output voltage? Can it measure it’s output voltage (at the SENSE pins) and provide the value in a register? I know that the output value can be calculated…
Part Number: TPS549D22
I have a question about the default values of the following registers on reset...
「 VOUT_COMMAND 」 「 VOUT_MARGIN_HIGH 」 「 VOUT_MARGIN_LO 」
The lower 10-bits are set by the pin-strap on boot/initializaiton. I understand that the initial boot…
Part Number: TPS549D22 Hi Team:
Can you help to comment on the following questions, thanks!
1: there is no statement on the PMBUS Pin , such as open drain, if this device is the open-drain type? if the external pull up is need? because there is no any…
Part Number: TPS549D22 Hi Ti Expert:
We have the design as below:
1. Vset=0.75V
2.Rtop=10K, Rbot=63.4K to get Vout=0.87V
Now, we need to adujst the Vout to 0.83V on the flying, what is the step to do it?
Thanks
Part Number: TPS549D22 Dear team
The customer would like to know how many programming times can TPS549D22 support, could you help to recommend?
Many thanks
Denny